Mr. Coffee ESX20 manual Water Filtration System Option, Brewing Coffee Now, Frame, Red, Indicator

Water Filtration System (Option)

Congratulations! You are the owner of the MR. COFFEE® Water Filtration System! This carbon-based water filter improves the taste of your coffee by removing up

to 97% of the chlorine from the water that you use to brew your coffee.

To use the water filtration system in your MR. COFFEE® Coffeemaker, please follow these steps:

First look for the MR. COFFEE Filtration Friendly symbol, , on the bottom of your brew basket. If you do not see this symbol, please call 1-800-MR COFFEE (1-800-672-6333).

1.If you have located the symbol , remove the gray disk cover from your water filtration system as shown in Diagram 1. Insert disk into the frame and replace cover.

2.Using the red indicator on the water filter, align the indicator to the letter on the frame that corresponds with the month that you are using the disk for the first time. This serves to remind you to change the disk every month.

3.Place a MR. COFFEE paper or permanent filter in the brew basket. Place coffee grounds in the paper or permanent filter.

For optimal results, use the water filtration system with a permanent filter.

4.Place the MR. COFFEE Water Filter in the brew basket, noting which side is up, as indicated on the water filter, and making sure the water filter is level.

5.Close the brew basket or lid. You are now ready to brew great tasting coffee. If the brew basket or lid does not close properly, then repeat Steps 4 – 5 to ensure that the filter has been properly inserted.

6.When you are done brewing your coffee, rinse the water filter with fresh water. Do not put your water filter in the dishwasher.

NOTE: Your water filtration disk will need to be replaced once a month (approximately 30 brew cycles). Replacement water filtration disks can be purchased through your local retailer or by calling 1-800-MR COFFEE (1-800-672-6333).

		Brewing Coffee Now
1		For Switch Models (ES12 & ES13):
		Push the switch so the light illuminates.
Frame		This light indicates that the coffeemaker is on and the
		brew cycle will begin. When the coffee stops flowing,
Filter Disk		the brew cycle is complete.
		While the coffee is brewing, the Pause ‘n
Disk Cover		Serve feature allows you to sneak a cup
		of coffee from the decanter. REPLACE
		THE DECANTER ON THE WARMING PLATE
Red		WITHIN 30 SECONDS TO PREVENT
Indicator	2	OVERFLOW AND POSSIBLE INJURY.

To turn off the coffeemaker, push the switch so the light is no longer illuminated.

	If the brew basket overflows or fails to empty
	into the decanter, do not open the brew
	basket. Turn off the coffeemaker. Unplug
3	the coffeemaker and wait for the contents
	to cool before handling.

For Programmable Models (ESX20 & ESX23):

Press the ON button when ready to start brewing.

Your coffeemaker will keep your coffee hot for 2 hours, then automatically shut off.

To turn the coffeemaker off, push the OFF button.

4

For Programmable Models (ESX39 & ESX40):

Press the SELECT button until the ON/OFF Indicator light is illuminated. Your coffeemaker will now begin brewing.

Your coffeemaker will keep your coffee hot	clean
for 2 hours, then automatically shut off.

To turn the coffeemaker off, press the SELECT button until the ON/OFF Indicator light is off.

5

10 11