H. DAILY CLEANING
WARNING
WHEN CLEANING THE OVEN:
•NEVER USE PRESSURIZED WATER.
•NEVER USE A CLEANING SOLUTION OTHER THAN SOAP AND WATER ON PORTIONS OF THE OVEN THAT COME INTO CONTACT WITH FOOD PRODUCTS. THESE AREAS INCLUDE THE CONVEYOR BELT AND END TRAYS.
•NEVER APPLY ENOUGH LIQUID TO STAND IN PLACE ON THE OVEN. LIQUID INSIDE THE OVEN WILL CAUSE A SEVERE ELECTRICAL HAZARD AND MAY OTHERWISE DAMAGE THE OVEN.
CAUTION
DO NOT clean your oven using abrasive cleaners or pads. Both will scratch and dull the finish.
1.With the conveyor running, use a brush to clean any crumbs off the conveyor into the crumb trays.
2.Switch the Power On/Off (I/O) switch to the OFF (“O”) position, and wait for the cooling fan to turn off.
3.Disconnect electrical power to the oven at the circuit breaker/fused disconnect.
4.Allow the oven to cool.
CAUTION - HOT
DO NOT TOUCH HOT SURFACES ON THE OVEN, OR REACH INTO THE COOKING CHAMBER, UNTIL THE UNIT HAS COOLED THOROUGHLY.
Figure 6
End crumb trays and fan grill
Clean fan grill
using stiff
nylon brush
Slide trays straight out
(trays are underneath both
ends of conveyor)
5. | Thoroughly clean the fan grill on the front of the oven |
|
| using a stiff nylon brush. See Figure 6. |
|
6. | Clean the end trays USING SOAP AND WATER |
|
| ONLY and towel them dry. If necessary, the end trays |
|
| can be removed for cleaning by removing the screws | ENGLISH |
| that hold them in place. See Figure 2 (in the | |
| Installation section of this Manual). | |
|
| |
| IMPORTANT |
|
| If the end trays are removed for cleaning, they must |
|
| be replaced prior to operating the oven. |
|
7. | Slide the end crumb trays out from underneath the |
|
| entrance and exit ends of the conveyor. See Figure |
|
| 6. |
|
8. | Lift BOTH ends of the center crumb tray; then, slide |
|
| the tray out of either end of the oven. |
|
9. | Clean all three of the crumb trays using a commercial |
|
| oven cleaner. If necessary, towel them dry. |
|
10. Replace the center crumb tray in the oven as shown |
| |
| in Figure 7. |
|
| IMPORTANT |
|
| Proper positioning of the center crumb tray is |
|
| REQUIRED for proper cooking. Ensure that the tray |
|
| is replaced inside the conveyor frame, as shown in |
|
| Figure 7, and NOT on the floor of the cooking chamber! |
|
11. Replace the two end crumb trays. |
| |
12. | Clean the outside of the oven using a damp cloth with |
|
| EITHER soap and water OR a stainless steel cleaner. |
|
| Use caution to ensure that liquids do not enter the |
|
| oven during cleaning, especially when wiping the fan |
|
| grill. |
|
Figure 7
Center crumb tray placement
| Tray fits | |
Conveyor | BETWEEN | |
conveyor belt | ||
belt | ||
and support | ||
| ||
Support | tab. | |
DO NOT | ||
tab | insert tray | |
| on floor of | |
| oven! |
9