INSTALLATION
ing from the drain line.
4.Observe cooker operation for several minutes. Op- eration is correct if timer dials begin to rotate after a short delay period required for preheating. After the delay period plus the “4 minute” initial setting, the timer dials will return to the “0 minute” position, at which a buzzer sounds. The buzzer is silenced by turning the dial to the OFF position.
SHUT-DOWN PROCEDURE:
No
REVERSING THE DOORS:
The Pressureless Steam Cooker has a reversible cooking compartment door. This section contains in- structions for reversing this door.
1.Open the cooking compartment door.
2.Remove the two screws that attach the top hinge to the front of the unit.
3.Slide the door upward, off the bottom hinge.
4.Remove the two screws that attach the bottom hinge to the front of the unit.
5.Remove the plastic hole plugs from the front of the unit. Push the black hole plugs into the
6.Reinstall the top hinge with spacers and screws into the
Rotate the hinge 180° for installation, so that the pin that the door rides on is now facing UP.
7.Remove the door latch assembly from the face of the unit. The two nuts mounting the door latch are located behind the face of the unit and must be accessed by removing the control panel. First
shut off the power to the unit at its source then remove the control panel by unscrewing the eight mounting screws and pulling the panel away from the front frame.
8.Remove the two white hole plugs from the left door latch mounting holes, and insert them into the right door latch mounting holes (where the door latch assembly was originally mounted).
9.Rotate the door latch assembly 180°, and install into the left door latch mounting holes.
NOTE: Each stud on the latch assembly should have a plastic washer, a spring, a plastic washer, and a Nyloc type nut.
10.To adjust the tension of the door latch, tighten both nuts down until the springs are fully compressed, then back each nut off 1/2 turn.
11.Replace the control panel, and reconnect the power to the unit.
12.Remove the inner door assembly by removing the six screws and spacers on the top and bottom of the door.
13.Move the magnet and magnet clip to the opposite side of the inner door panel (see fig. 5, page 20).
14.Put the door back together, making sure the mag- net is located at the top of the door, and refasten it together with the six screws and spacers into the top and bottom of the door.
15.Rotate the door 180° for mounting.
16.Slide the remaining hinge into the top door bear- ing.
17.Slide the door and hinge assembly down onto the hinge that you have already mounted to the front of the unit. Use the two to mount the top hinge into the right upper hinge mounting holes.
NOTE: Be sure to include spacer washers behind
OPERATION
OPERATING CONTROLS AND INDICATORS:
The controls and indicators required to operate the Pressureless Steam Cooker are listed in Table 1 on page 5, together with a short functional description of each. Figure 1 on page 5 shows the physical location of each control and indicator.
OPERATING PROCEDURES:
The 3500 Pressureless Steam Cooker defrosts fro- zen foods and cooks fresh and defrosted foods. Each cooking compartment permits selection of continuous (constant steam) cooking or timed
3