Craftsman 580.7471 owner manual Training, Preparation, Operation, Maintenance and Storage

SAFETY RULES

CAUTION: ALWAYS DISCONNECT SPARK PLUG WIRE AND PLACE WIRE WHERE IT CANNOT

CONTACT SPARK PLUG, TO PREVENT ACCIDENTAL STARTING WHEN SETTING UP, TRANS- PORTING, ADJUSTING OR MAKING REPAIRS TO YOUR HIGH PRESSURE WASHER.

TRAINING:

=Engine exhaust gases contain DEADLY carbon mon-

oxide gas., This dangerous gas, if breathed in suffi- cient concentrations, can cause unconsciousness or

. even death., Operate this equipment only in the open air where adequate ventilation is avaitable_

•Gasoline is higl_ly FLAMMABLE and its vapors are EXPLOSIVE. Do not permit smoking, open flames, sparks or heat in the vicinity while handling gasoline. Avoid spilling gasoline on a hot engine° Allow unit to

•High pressure spray can cause paint chips or'other particles to become airborne and fly at high speeds.

•Always wear eye protection when you use this equip-

ment or when you are in the vicinity where the equip- ment is in use.

•Operate the pressure at no more than the PS1 fluid pressure rated for'your pressure washer,.

'_ Never move the machine by pulling on the high pres-

sure hose,. Use the handle provided on the top of the unit,,

cool for 2 minutes before refueling. Comply with all taws regulating storage and handling of gasoline.

"Locate this pressure washer in areas away from corn- bustible materials, combustible fumes or dust..

oThe high pressure equipment is designed to be used with Sears authorized parts only. If you use this equipment with parts that do not comply with minimum specifications, the user assumes all risks and liabili- ties.,

•Some chemicals or detergents may be harmful if inhaled or ingested, causing severe nausea, fainting or poisoning. The harmful elements may cause prop- erty damage or severe injury..

oDo not allow CHILDREN to operate the Pressure Washer at any time.

PREPARATION:

oOperate engine only at governed speed.. Running the engine at excessive speeds increases the hazard of personal injury. Do not tamper with parts which may increase or decrease the governed speed.,

oDo not wear loose clothing, jewelry or anything that may be caught in the starter or other rotating parts,.

=Before starting the Pressure Washer in cold weather,

check all parts of the equipment and be sure ice has not formed there,.

"Units with broken or missing parts, or without protec- tive housing or covers should NEVER be operated.,

oThe muffler and air cleaner must be installed and in good condition before operating the Pressure Washer.

These components act as spark arrestors if the engine backfires_

•Check the fuet system for leaks or signs of deteriora- tion such as chafed or spongy hose, loose or missing clamps or damaged tank or cap. Correct all defects before operating the Pressure Washer.

OPERATION;

"Do not spray flammable liquids,

o Never aim the gun at people, animals or plants..

=Never allow any part of the body to come in contact with the fluid stream. DO NOT come in contact with a

fluid stream created by a leak in the high pressure hose.

•High pressure stream of fluid that this equipment can produce can pierce skin and its underlying tissues, leading to serious injury and possible amputationv

oAlways be certain the spray gun, nozzles and acces- sories are correctly attached.

•Never use a spray gun which does not have a trigger lock or trigger'guard in place and in working order.

•Use a respirator or mask whenever there is a chance that vapors may be inhaled,. Read all instructions with the mask so you are certain the mask will provide the necessary protection against inhaling harmful vapors.

•High pressure spray may damage fragile items includ- ing glass, Do not point spray gun at glass when in the jet spray mode,

•Keep the hose connected to machine or the spray gun while the system is pressurized.. Disconnecting the hose while the unit is pressurized is dangerous,

•Hold the spray gun firmly in your'hand before you start the unit., Failure to do so could result in an injury from a whipping spray gun_ Do not leave the spray gun unattended while the machine is running.

•The cleaning area should have adequate slopes and drainage to reduce the possibility of a fall due to slippery surfaces_

•Keep water spray away from electric wiring or fatal electric shock may resulL

oDo not adjust unloader valve to a pressure in excess of machine rating.

oDo not secure trigger gun in the pull-back (open) position.

•Do not by-pass any safety device on this machine,

•Do not leave trigger closed for more than 5 minutes with engine running. This could damage the pump.

•The muffler and engine heat up during operation and remain hot immediately after shutting it down. Avoid contact with a hot muffler or engine or you could be severely burned.

MAINTENANCE AND STORAGE;

•Operate and store this unit on a stable surface.

•High pressure hose can develop leaks from wear, kinking, abuse, etc. Water spraying from a leak is capable of injecting material into skin, Inspect hose each time before using iL Check all hoses for cuts, leaks, abrasions or bulging of cover, or damage or movement of couplings. If any of these conditions exist, replace hose immediately_ Never repair high pressure hose. Replace it with another hose that

meets minimum pressure rating of your'pressure washer.

LOOK FOR THIS SYMBOL TO POINT OUT IMPORTANT

SAFETY PRECAUTIONS° IT MEANS "ATTENTION!!! BE-

COME ALERT!!! YOUR.SAFETY IS INVOLVED."