Desa Tech S26PT installation manual Operating Heater, For Your Safety Read Before Lighting

OWNER’S MANUAL

INSTALLATION

Continued

13.Install plastic control knob onto output shaft of speed control housing (see Fig- ure 16). Place speed control housing just inside control compartment door in front of stove (see Figure 17).

14.Using two screws provided in blower kit, mount blower speed control hous- ing to mounting tab in left side of lower control compartment (see Figure 17).

15.Check to make sure that the power cord is completely clear of blower wheel and there are no foreign objects in blower wheel.

16.Carefully replace stove top panel. Align holes and replace six screws removed in step 1, page 10.

17.Peel off the backing paper and stick the supplied wiring diagram decal on the stove floor as shown in Figure 16.

18.Plug power cord into a convenient 3-prong grounded wall receptacle near the stove.

WARNING: ELECTRICAL GROUNDING INSTRUCTIONS This appliance is equipped with a three-prong (grounding) plug for your protection against shock hazard and should be plugged directly into a properly grounded three-prong receptacle.

19.Using speed control knob, turn blower on and check for operation.

20.All remaining parts from blower kit may be discarded.

Blower Speed

Control Housing

Figure17 -InstallingBlowerControlHousing

OPERATING HEATER

FOR YOUR SAFETY

READ BEFORE

LIGHTING

WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result caus- ing property damage, personal injury or loss of life.

A.	This appliance has a pilot which must
	be lighted by hand. When lighting the
	pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all
	around the appliance area for gas. Be
	sure to smell next to the floor because
	some gas is heavier than air and will
	settle on the floor.
	WHAT TO DO IF YOU SMELL GAS
	• Do not try to light any appliance.
	• Do not touch any electric switch; do
	not use any phone in your building.
	• Immediately call your gas supplier
	from a neighbor’s phone. Follow
	the gas supplier’s instructions.
	• If you cannot reach your gas sup-
	plier, call the fire department.
C.	Use only your hand to push in or turn

Power

Cord

Wiring

Diagram

Decal

Control	Speed Control
Knob	Housing

Figure 16 - Routing Power Cord

WARNING: Never attempt to service heater while it is plugged in, operating, or hot. Burns and electrical shock could result. Only a qualified service person should service or repair heater.

If any of the original wire as supplied with the appliance must be replaced, it must be replaced with 105°C wire or it’s equivalent.

WARNING: Label all wires prior to disconnection when servicing controls. Wiring errors can cause im- proper and dangerous operation. Verify proper opera- tion after servicing.

Variable

			Fan Switch
	V.A.C.		Off	Black	On
			Black			Motor
110/115						Blower
		Black				Black
		Green
		White				White

120 Vac. 60 Hz. . 78 Amps
DESA International, Bowling Green, KY	101584-05

the gas control knob. Never use tools.

If the knob will not push in or turn

by hand, don’t try to repair it, call a

qualified service technician or gas

supplier. Force or attempted repair

may result in a fire or explosion.

D. Do not use this appliance if any part

has been under water. Immediately call

a qualified service technician to inspect

the appliance and to replace any part

of the control system and any gas con-

trol which has been under water.

Continued

105684 11 For more information, visit www.desatech.com