Automatic Mode Operation

Vacuum Port

WARNING! Before cleaning, assembling or disassembling the Vacuum Sealer, make sure the Vacuum Sealer is OFF and the PLUG IS REMOVED FROM THE OUTLET/POWER SOURCE!

BEFORE ATTEMPTING VACUUM PACKAGING BE SURE THAT THE VACUUM SEALER IS SET UP IN ACCORDANCE WITH ALL OF THE SAFETY PRECAUTIONS LISTED IN THIS BOOKLET.

WARNING! Before cleaning, assembling or disassembling the Vacuum Sealer, make sure the Vacuum Sealer is OFF and the PLUG IS REMOVED FROM THE OUTLET/POWER SOURCE!

MANUAL MODE OPERATION

BEFORE ATTEMPTING VACUUM PACKAGING, BE SURE THAT THE VACUUM SEALER IS SET UP IN ACCORDANCE WITH ALL OF THE SAFETY PRECAUTIONS LISTED IN THIS BOOKLET.

Vacuum Port

1.With the Vacuum Sealer plugged in and the power turned on, check to be sure the Auto Mode Light is illuminated; press the Mode Button until the Auto Light is on.

2.Place the items to be vacuum sealed into a vacuum bag. Allow at least 2” (5 cm) at the open end of the bag in order to create enough seal space. Be sure not to cover the Vacuum Port (Figure C).

3.Close the Vacuum Lid and check that the bag opening is in the center of the Vacuum Chamber.

4.Press and release the Start Button. The 2-Piston Vacuum Pump will begin removing air from the bag while the LED Vacuum Window begins to count up. You may need to apply light pressure to the Vacuum Lid during the count-up process. The LED Vacuum Window will count up starting at the number “1” and going thru to the number “9”, before automatically engaging the bag sealing process. These numbers represent stages, not seconds.

Figure C

Leave 2”

Seal

Space

1. With the Vacuum Sealer plugged in

and the power turned on, check to be sure

the Manual Mode Light is illuminated; if not

press the Mode Button until the manual light

is on.

2. Place the items to be vacuum sealed into a vacuum bag. Allow at least 2” (5 cm) at the open end of the bag in order to create enough seal space. Be sure not to cover the Vacuum Ports (Figure D).

3.Close the Vacuum Lid and check that the bag opening is in the center of the Vacuum Chamber.

4. While monitoring the vacuum bag, press and release START Button. The 2-Piston Vacuum Pump will begin removing air from the bag. When the desired level of air has been evacuated from the bag, press and release the Manual Bag Seal Button. It will start the sealing bag process.

Note: You may need to apply light pressure to the Vacuum Lid during this process.

Figure D

Leave 2”

Seal

Space

5.Once the LED Vacuum Window displays the number “9”, the sealing process will begin by counting down from your chosen setting to “0” on the LED Seal Window.

6.Once the LED Seal Window has reached “0”, the Vacuum Sealer will automatically stop the 2-Piston Vacuum Pump and release the vacuum pressure moments later. DO NOT ATTEMPT TO PULL THE VACUUM LID OPEN BEFORE

THE VACUUM HAS BEEN RELEASED, SEVERE DAMAGE TO THE SEALING BAR WILL RESULT.

NOTE: The Vacuum Sealer is ONLY intended to be used with VACUUM BAGS. For best results, only use the recommended vacuum bags. DO NOT USE HOUSEHOLD BAGS! Any other uses of the Vacuum Sealer, other than the uses described in this booklet, could potentially damage the appliance and void the warranty!

-12-

Note: It requires some vacuum pressure in the bag to get good seal for the bag.

5.Once the LED Seal Window has reached “0”, the Vacuum Sealer will automatically stop the Vacuum Pump and release the vacuum pressure moments later. DO NOT ATTEMPT TO PULL THE VACUUM LID OPEN BEFORE THE

VACUUM HAS BEEN RELEASED, SEVERE DAMAGE TO THE SEALING BAR WILL RESULT.

-13-