Globe SP8 Operating Instructions, To Avoid Serious Personal Injury, Mixing Ingredients

Operating Instructions

TO AVOID SERIOUS PERSONAL INJURY:

•DO NOT operate the mixer before reading the instruction manual first.

•ALWAYS disconnect or unplug electrical power before cleaning, servicing, or adjusting any parts or attachments.

•ALWAYS keep hands, hair, and clothing away from moving parts.

ATTACHING THE BOWL TO THE MIXER

NOTE: Install the bowl BEFORE attaching the agitators.

1.Lower the bowl by pushing the bowl lift lever backwards and down to its resting position.

2.Lift the bowl by the bowl handle and

a.slowly position the locking pin (located on the rear of the bowl) into the hole in the middle rear of the cradle (see fig 7-1).

b.lower the bowl onto the pins located on either side of the bowl cradle.

3.Once the bowl is positioned on the cradle, secure the bowl by pulling both bowl clamps forward until the bowl is locked tight (see fig 7-2).

Fig. 7-1

Fig. 7-2

ATTACHING THE AGITATOR TO THE MIXER (i.e., Beater, Hook, Whip)

NOTE: It is easier to install the agitator prior to adding the ingredients into the bowl.

1.The bowl should be in the lowered position and the bowl guard should be removed (see fig 7-3).

2.Slide the agitator slowly upwards onto the planetary shaft fitting the shaft pin through the slot in the agitator (see fig 7-4).

3. Rotate the agitator clockwise to secure it onto the planetary shaft (see fig 7-5). Fig. 7-3

MIXING INGREDIENTS

Follow the capacity chart located on page 12 in this owners manual. Overloading or not following this chart will damage the mixer and void the warranty.

IMPORTANT: Make sure the speed control lever is on the first (1) speed.

Fig. 7-4 Fig. 7-5

1. Add the appropriate mixing ingredients into the bowl.

Page 7