Globe GL12 instruction manual Be ALERT. The next step will expose the knife

CLEANING

6.Turn the knife cover release knob counterclockwise (Fig. 12-1) until it drops into position (Fig. 12-2)

BE ALERT. The next step will expose the knife.

7.While holding the upper knob and lower handle on the knife cover (Fig. 12-3), lift the knife cover upward to remove it

from the slicer (Fig. 12-4). Figure 12-1 Figure 12-2

NOTE: Slicer will not operate with the knife cover removed.

NEVER attempt to remove or dismantle the knife ring guard.

NEVER try to remove the knife from the slicer. It must remain on the slicer for proper operation, sharpening, and cleaning.

Figure 12-3 Figure 12-4

•DO NOT put components in dishwasher.

•Dilute detergent per supplier’s instruction. Products containing sodium hypochlorite should not be used on the slicer.

•DO NOT hose down, pressure wash, or pour water on the slicer.

•NEVER use scrubber pad, steel wool, or abrasive material to clean the slicer.

•NEVER remove sharpener from slicer or immerse in water.

•Clean the disassembled components with a mild detergent and warm water solution. Allow parts to air dry.

ALWAYS turn off slicer and unplug power cord BEFORE cleaning.

8.To clean the knife ring guard, soak a clean cloth in a mild detergent and warm water solution. Ring out excess water from cloth. Carefully insert the cloth between the knife and the knife ring guard (Fig. 12-5). While holding the cloth between the knife and the knife ring guard, work it along

the entire backside of the knife. Repeat this procedure as necessary.	Figure 12-5
A nylon brush could also be used if preferred.

9.The knife must also be cleaned. Carefully wash and rinse the top and bottom of the knife by wiping from the center of the knife outward (Fig. 12-6).

DO NOT allow moisture to get into knife hub.

Figure 12-6

Page 12