CLEANING INSTRUCTIONS
The Ecalibur blender container parts are corrosion resistant, sanitary and easily cleaned. Do not put the container assembly or blender base assembly in the dishwasher.
1.Before first use and after every use, separate container parts from the base.
2.To clean the container: Use a washing solution of tepid water (less than 115°F/46°C) and a
3.Scrub and flush out the container interior lid and feeder cap to remove food residue. Empty container.
4.Fill container 1/4 full with fresh washing solution and place it on the base.
5.Replace the lid and feeder cap on the container and run the blender on high speed for 2 minutes.
6.Repeat step 4 using clean rinse water (95°F/35°C).
7.Wipe down the outside of container, feeder cap, and lid with a soft cloth or sponge, dampened with fresh washing solution.
8.Wipe the exterior of the base with a damp cloth or sponge. The base contains electrical components: do not immerse. use a
BLENDER CARE
For best results:
1.Periodically check all parts before reassembly. Use of damaged or
2.Blades:
If the processing blades are stuck or difficult to turn. DO NOT USE BLENDER. Remove container from the base. Check by carefully turning the blades in a counter- clockwise direction, where the opposite edges are sharp. Blades should turn freely.
3.Container:
If the EASTMAN TRITAN™ container is cracked, DO NOT USE BLENDER, further use could result in the container breakage during use.
4.Blender Base:
Never immerse the blender base in water. To clean, unplug base and use a damp cloth.
5.Motor:
The motor is permanently lubricated and does not require any additional lubrication.
8