MKG SERIES GAS GRIDDLE | INSTALLATION & OPERATION |
1.5. INSTALLATION, SET UP:
The installation of this appliance MUST conform to local codes. In the absence of local codes, the installation must conform to the National Fuel Gas Code, ANSI Z223.1; Natural Gas Installation Code,
A. Uncrate appliance and locate installation accessories shipped with the appliance.
1.5.1. For Counter Use With Legs:
CAUTION
To prevent equipment damage, DO NOT tilt your MagiKitch'n
griddle on only two legs, or on its sides.
A. (See picture at right) A set of 4” legs is shipped with the appliance (unless appliance was specifically ordered without legs). A threaded receptacle is located near each corner of the underside of the base of the appliance, on appliances 48" and wider there are threaded receptacles in the front and rear center of the base. Each leg has a similar mating thread. Raise appliance sufficiently to allow legs to be screwed tightly into receptacles. The appliance can be leveled by adjusting the feet at the bottom of the leg assembly. This can be done by turning the foot in or out to lower or raise each corner as needed.
NOTICE
4" Legs should not to be used with the optional Equipment Stand.
CAUTION
The appliance must be level to perform properly. Failure to level unit may result in improper combustion and performance of
the appliance.
1.5.2. For Counter Use Without Legs:
A.(See picture at right) The appliance must be sealed to the counter to comply with applicable sanitation standards. A bead of silicone sealant, approximately ½ inch wide, is to be applied to the bottom of the unit approximately ¼” in
from the front, back and side edges. We suggest Dow Corning ®, GE ® or Permatex ® silicone ‘RTV’ adhesive sealant or equivalent. (See NSF Basic Criteria
3