USING YOUR MaxiMixer
READ CAREFULLY
SETUP
1.When you are delivered your new MaxiMixer from the factory, it is not immediately necessary to check the machine for bearing lubrication or chain tightness, as these items have been factory serviced. It is recommended to walk around the machine and familiarize yourself with the location of all moving parts, caution decals, the general operating dimensions, and the basic working features of the MaxiMixer.
CAUTION! BEFORE OPERATING THIS MACHINE, READ AND
UNDERSTAND THIS OWNER'S MANUAL AND ALL CAUTION, WARNING, AND DANGER SYMBOLS LOCATED ON THE MACHINE AND IN THIS MANUAL.
2.All lubrication has been completed at the factory prior to delivery and will not be immediately necessary. For Lubrication intervals and specifications see the enclosed Lubrication Schedule.
IMPORTANT! DO NOT OVER GREASE BEARINGS, SEAL FAILURE AND SUBSEQUENT PREMATURE BEARING FAILURE COULD RESULT.
3.When you receive your MaxiMixer, it will be first necessary for you to hook up the power source for the solenoid that switches power between the hydraulic functions (if so equipped). The switch box is supplied with a lead that has 1 white wire and 1 black wire. The white wire is to be hooked to positive and the black is to be hooked to ground. It is recommended to hook these leads into a switched power source such as a keyed ignition. This will eliminate the possibility of draining the battery if the switch is left on. When not in use, be sure to turn unit off.
IMPORTANT: ALWAYS KEEP POWER CONNECTIONS TIGHT, NEAT AND FREE FROM DIRT AND CORROSION! DO NOT HOOK THE LEADS FOR THE SWITCH BOX INTO THE MIXER MOUNTED BATTERY THAT SUPPLIES THE SCALE!
The leads for the switch box have been supplied with and inline fuse holder that holds a 10 amp fuse.
CAUTION! DO NOT REPLACE A BLOWN FUSE WITH A FUSE OF A
HIGHER RATING!
3