Saeco Coffee Makers HD8833 manual Coffee Brewing, Stand-by

Page 11

The machine allows slight adjustments to the coff ee grinder to adapt it to the kind of coffee used.

To make any adjustment, press and turn the knob inside the coffee bean hopper.

Press and turn the knob by one notch at

atime and brew 2-3 cups of coffee; this is the only way to notice differences in grind.

The reference marks inside the coffee bean hopper indicate the grind setting. There are 5 different grind settings to cho- ose from with the following references:

Large Mark - Coarse Grind

Small Mark - Fine Grind.

Adjusting the Coffee Length

The machine allows you to adjust the amount of brewed coffee according to your taste and/or the size of your cups.

Each time the “” or “” buttons are

pressed and released, the machine brews

a pre-set amount of coffee, as per factory

settings. This amount may be reprogram-

med to your taste. Each button may be

individually programmed for a specific brew setting.

As an example, the following procedure describes the programming of the but- ton“”, which is normally associated with espresso coffee.

• Place a cup under the dispensing spout.

•Hold the “” button pressed for 5 seconds to enter the programming

 

mode; the button “

” blinks together

 

with the lights of the display shown in

Blinking

the fi gure and the coffee will start to

 

be brewed. These light signals remain

 

 

active during the whole cycle.

•Press the“”button again when the amount of coffee in the cup reaches the desired level.

At this point the button“”is program- med; each time it is pressed and released, the machine will brew the same amount of coffee that was just programmed.

Stand-by

The machine is designed for energy sa- ving. The machine automatically turns off after 30 minutes of inactivity.

The“ “ button blinks when the machine is in stand-by mode.

Note: During the turning off phase, the machine performs a rinse cycle, if a coffee product has

been brewed.

Warning: When turning the machine on after it has been turned com- pletely off, the machine will be in stand-by mode

To turn the machine on again simply press the STAND-BY button (if the power but- ton is set to “I”). In this case the machine will go through the rinse cycle only if the boiler is cold.

COFFEE BREWING

Note: Should the machine not brew coffee, make sure that

the water tank contains water.

 

Before brewing coffee, check

 

the lights on the display and

 

on the control panel. Check that

 

the water tank and the coffee bean

Steady on

hopper are full.

 

 

Leave the selector on the

Steady on

coffee position “ ” during the

dispensing phase.

 

 

Before brewing the coffee,

 

adjust the height of the di-

 

spensing spout according to your

 

needs, and select the aroma or the

 

pre-ground coffee.

• 11 •

Page 10 Page 12
Image 11
Page 10 Page 12
Contents SUP 037R Important Safeguards Instructions for the Power Supply Cord General Information Safety RegulationsPower Supply Power Cord For the Safety of OthersSpensing spout Storing the Machine CleaningServicing / Maintenance Fire Safety PrecautionsHot water/steam selector dial Grinder adjustment Knob Coffee bean hopperSelector switch Preliminary Operations InstallationMachine Packaging Circuit Priming Do not add the pre-ground Rinse/Self-cleaning CycleSaeco Adapting System AdjustmentsCoffee Grinder Adjustment Intenza water filter op- tionalStand-by Coffee BrewingAroma Adjustment Dispensing Spout AdjustmentUsing Coffee Beans Coffees Dispensing HOT WaterTed coffee Cino Needed to dispense coffee Cleaning and Main TenancePlied to obtain a thorough cleaning Straight afterPannarello Also clean the seat of the tray everyService centres Brew GroupBrewed product Adding the descaling solution Empty the containersDescaling During the descaling processWhen When the button is lit up steadyTurn the selector dial to the posi- tion Water continuouslyBe repeated from point And/or the regulations in force in the country of use Maintenance chapterRemarks on descaling Control Panel Display Ready SignalsBrew group overstressed Alarm SignalsTion Machine Actions Causes Solutions TroubleshootingMachine Disposal Technical SpecificationsPage Page Page Rev.00 del

HD8833 specifications

The Saeco Coffee Maker HD8833 is a premium automatic espresso machine designed for coffee enthusiasts who seek a perfect brewing experience right at home. This elegant machine is part of Saeco’s renowned family of espresso makers, which are known for their quality, durability, and innovative features.

One of the standout features of the Saeco HD8833 is its intuitive interface, equipped with a user-friendly control panel that makes it easy to customize your coffee preferences. The machine’s adjustable settings allow users to select the strength, temperature, and volume of their espresso, ensuring every cup is tailored to individual tastes.

The Saeco HD8833 utilizes a powerful ceramic grinder, which operates quietly and efficiently. Unlike steel grinders that can overheat and impact the flavor of the beans, the ceramic grinder maintains a consistent grind size and helps preserve the natural oils and aromas of the coffee. Additionally, the grinder is adjustable, allowing users to choose from five different grind settings, from coarse to fine.

Another key technology in the HD8833 is the AquaClean water filter. This innovative feature not only improves the quality of the water for brewing but also helps reduce the scale buildup in the machine. With the AquaClean filter, users can brew up to 5,000 cups of coffee without the need for descaling, making maintenance a breeze.

The machine’s milk frothing system is also noteworthy. The automatic milk frother allows users to create rich, creamy milk froth for their lattes and cappuccinos with ease. The HD8833’s integrated milk carafe can be stored in the refrigerator, ensuring that the milk stays fresh and ready for use.

Another highlight of the Saeco Coffee Maker HD8833 is its removable brewing group. This component can be easily removed for cleaning, ensuring hygiene and optimal coffee quality. The sleek design of the machine not only looks great on any countertop but also features a compact size that fits well in various kitchen spaces.

In summary, the Saeco Coffee Maker HD8833 combines convenience with advanced coffee-making technology. With its customizable options, durable ceramic grinder, AquaClean filter, and user-friendly design, it represents an excellent choice for anyone looking to elevate their coffee experience at home. Whether you're a seasoned barista or a casual coffee drinker, the HD8833 promises to deliver a rich and satisfying cup of espresso every time.
Top Page Image Contents