Saeco Coffee Makers HD8833 manual Rinse/Self-cleaning Cycle, Do not add the pre-ground

Using the machine for the first time or after a long period of inactivity.

These simple operations will make it pos- sible to always brew excellent coffee.

1 Place a large container under the dispensing spout.

	2 Before starting the procedure, check
	that the following icon is displayed and
	that the buttons “	” and “	” on
Steady on	the control panel are steady on.
	3 Select the pre-ground coffee function
	by pressing the “	“ button one or
	more times.
	Do not add the pre-ground
	coffee to the compartment.

	9 Dispense water until the no water si-
	gnal is displayed, then turn the selec-
	tor dial counter-clockwise to set it to
Steady on	the “ ”position.

10 At the end, fill the water tank again. Then the products can be brewed as described in the following sections.

The icon will appear on the display.

Steady on

4 Press the button to brew a long cof- fee.

5 Wait until brewing is completed and empty the container.

6 Repeat the operations from step 1 to step 5 for 3 times; then continue with step 7.

7 Place a container under the steam wand (Pannarello, if supplied).

8 Turn the selector dial clockwise to set it to the “”position.

Blinking

Rinse/Self-cleaning Cycle

This cycle allow rinsing the coffee circuits with fresh water.

The cycle is carried out:

•At machine start (with cold boiler)

•After priming the water circuit (with cold boiler)

•During the Stand-by preparation phase (if a coffee product has been brewed)

•During the phase of activating the stand-by mode after pressing the “STAND-BY”button (if a coffee product has been brewed).

A small amount of water will be dispen- sed, which will rinse and heat all the ma- chine components; in this phase the but- tons “”and “”blink alternately.

Wait for the cycle to fi nish automatically.

You can stop dispensing by pressing either of the two brew buttons.

• 9 •