TriStar SSMT1000 manual Troubleshooting, Important Safeguards

TROUBLESHOOTING

Problem		Possible Reasons and Solution
The motor does not	•	Check to see if unit is plugged in.
run after being	•	Locking bar is not locked in place properly.
switched on.
	•	Check if all parts are assembled properly.
	•	Check if there is any residue left between
		blade and receptacle.
	•	Check to see if food is stuck to the bottom of
		the pusher.
The motor is running	•	Check that all parts are assembled properly
with loud noise and		and in the correct position.
shaking.	•	Juicing overripe fruit may result in too much
		pulp and will clog the filter. Turn machine off
		and clean the filter.
The motor is running.	•	Turn the power off and unplug the machine.
The spout is in the		Wait for blade to stop spinning. Use a
downward position,		toothpick to loosen any obstruction in the
but no juice is coming		non-drip spout.
out.
The motor overheats	•	The motor needs to warm up for 10 seconds
causing the power to		before use.
automatically shut off.	•	The fruits and vegetables may be soft
		or overripe.
	•	There may be too much pulp in the filter.
		Turn machine off and clean the filter.
	•	Motor stops running due to the built-in
		feature, the overheat safety control.
Juice splashes from the	•	This is normal.
rim of the receptacle.
10

IMPORTANT SAFEGUARDS

READ THESE SAFEGUARDS CAREFULLY

BEFORE USING THIS PRODUCT!

•NOT FOR USE BY CHILDREN! Keep out of the reach of children to avoid injury. This appliance is not a toy.

•Make sure the lid is attached properly and securely locked before operating the Power Juicer.

•Do not unfasten the locking bar during operation.

•To avoid risk of injury keep hands and utensils out of the juicer and away from its sharp blade during operation.

•Use the pusher, not fingers or utensils, to propel the food into the juicer.

•Should food become lodged in the opening use pusher to push it down. If food remains stuck, turn the power off, wait until motor stops, unit shuts down completely, and is unplugged before disassembling the juicer and removing the blocked food.

•Make sure the motor stops completely and the unit is unplugged from the electrical outlet before cleaning, putting on or removing parts.

•To protect against risk of electrical shock or injury, never immerse power cord, plug, or main unit in water, or other liquids.

•If juicer stops due to improper operation or if there is excessive noise, turn power off, wait for blade to stop spinning, unplug from electrical outlet, disassemble and clean all components then reassemble machine.

•Do not operate this or any appliance with a damaged cord or plug.

•Do not operate if appliance malfunctions, is dropped or damaged in any manner. Let a qualified appliance repair person examine and or repair appliance before using.

•To avoid electric shock or serious injury do not use any attachments that were not recommended or sold by the manufacturer.

•Do not let power cord hang over the edge of table, counter, or let cord touch hot surfaces such as stoves.

•To reduce the risk of injury, never place blade on base without properly assembling the unit.

•This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not modify or force the plug in any way.

•The motor will not run if unit is not properly assembled. The motor has a built-in safety feature that will not let the power turn on unless the locking bar is locked in place.

3