ASSEMBLY Assemble as shown
ASSEMBLY(CONT.)
1 Base
Locking
Bar
Front of
Machine
(Spout side)
STEP 1:
2
Lip
Juice Spout
Receptacle
Base
STEP 2:
STEP 5:
Place lid with pulp guard attached on top of receptacle, making certain it is snugly aligned with the pulp guard facing in the opposite direction of the juice spout. Lock lid into place by lifting locking bar up until it clicks into grooves located
on both sides of the lid. Make sure locking bar is in the full upright, locked position.
IMPORTANT: The unit will not start until this bar is properly locked in place.
5 |
|
| Lid with | |||
|
|
|
| |||
|
|
|
| Pulp Guard | ||
Receptacle |
|
| Pulp | |||
|
|
|
| Collector | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Place base on a dry flat surface with | Place receptacle on the base, with |
locking bar in down position as shown. | juicer spout facing direction of locking |
In front of the machine (spout side). | bar. Settle receptacle into alignment. |
STEP 6:
Insert pusher into chute. Always use pusher to feed fruits
6 Pusher
3 |
|
| 4 |
FilterCrescent
Receptacle Tool
Blade
Holes
Blade
Filter
and vegetables into unit. Push gently, never force. The blade will do the work.
STEP 7:
Chute
Lid with Pulp Guard
STEP 3:
Place filter inside receptacle, matching the opening on its bottom to the screw peg connected to the base.
STEP 4:
Place blade inside filter, centered over screw peg. Using orange crescent tool, place its pegs into the holes in the blade and turn clockwise until tightened.
Make sure juice spout is in the downward position. If the juice spout is left in the upright position the juice will not flow. It will stay in the receptacle and may overflow from the sides.
7
6
IMPORTANT: Do not over tighten as the screw peg will break. Remove crescent tool and set aside.
CAUTION: Do not leave tool inside juicer.
UPRIGHT POSITION
DOWNWARD POSITION
7