Kenmore SF22-804 instruction sheet Do not Over Tighten Screw

Page 3

Date: 12/28/07

Parts& RepaLrServices

SF22-804

Page 3 of 6

3.Position the new switch as shown in the photo. The new switch is held in place by a single screw on one end and the tab from the mounting bracket on the other end.

4.Secure the switch with the long screw and speed nut.

DO NOT OVER TIGHTEN SCREW.

5.Reinstall the lock motor onto the bracket. Make sure that the cam on the motor is pressing the plunger of the new switch.

6.Re install the lock motor assembly onto the chassis. Take care to ensure the

latch rod is properly inserted into the motor couplinc].

Confidential Information -For Internal Use Only

DEPARTMENT 702HSX - Leo Steinys DEPARTMENT 702PSO - Bob Vondale

Image 3
Contents LR% /g LAS H Parts& RepaLrServices Do not Over Tighten Screw From Kit New switch Special Service Order Close Information