Date: 12/28/07 | Parts& RepaLrServices |
SF22-804
Page 4 of 6
7.Install the resistor on the rear wall as
shown in the photo. Carefully punch or drill a starter hole for the screw if
necessary.
8.Use existing screw holes to install the new 120 ° thermostat to the left of the
existing 170 ° thermostat. Mark the chassis with an "X "or "120" to identify the new thermostat.
9. Install wire # 1 (318052584) | onto the | 10. Disconnect | the | power wire | from | the | |||||
"C" | terminal of the | new switch. | This | 170 ° thermostat, | cut | off the | terminal | ||||
wire | has | a push on | terminal | on | one | connector | and | strip | approx. | 3/16 | inch |
end | and | is stripped | on the | other | end. | of the insulation. | The power | wire | is | ||
|
|
|
|
|
| the one that does not connect to the | |||||
|
|
|
|
|
| fan motor. |
|
|
|
|
|
(318052584 From Kit
Confidential Information
DEPARTMENT 702HSX - Leo Steinys
DEPARTMENT 702PSO - Bob Vondale