Kenmore 790.4626 manual Setting Oven Controls contd, Failure Modes

Page 14

Setting Oven Controls (cont'd)

Adjusting Your Oven Temperature

Your new oven has been factory calibrated and tested to ensure an accurate baking temperature. For the first few uses, follow your recipe times and temperature recommendations carefully, if you feel your oven is too hot or too cool from your baking experience, the oven temperature may be adjusted to your liking.

Note: DO NOT adjust your oven temperature based on oven thermometers, such as those found in grocery stores, they may not be accurate.

To Adjust the Oven Temperature (do not use Bake or Broil while adjusting the oven temperature):

1.Press & hold the I key pad and release after the display shows the factory temperature setting of 00.

Note: If the oven temperature has been previously adjusted from the factory setting, the current temperature adjusted value will appear in the display instead.

2.You may increase the oven temperature in 5°F increments with each press of the/k key pad to a maximum oven adjustment of +35°F. You may also adjust the oven temperature downward in 5°F increments with each press of the v key pad ( total range of -35to +35 ). Note: Your oven control was factory set in the (Fahrenheit) °F Temperature

Display Mode. To change for (Celsius) °C, see Changing the Temperature Display Mode in the Oven Control Functions section of this Use & Care Manual.

3.If no other key pad is pressed after 5 seconds the display will begin to flash.

4. If you do not want to keep the display adjustment, press the _ key pad before the oven control beeps. This will

cancel the temperature adjustment procedure. To start this procedure over again begin with step 1 above OR;

5.If you want to keep the adjustment, wait until the display quits flashing and the oven control beeps once.

6.The oven temperature adjustment has be accepted by the oven control and the display will return to the time of day. Notes: The oven temperature adjustment may be made if your oven control has been set to operate in the (Celsius) °C Temperature Display Mode. in this case each press of the A or v key will adjust in 1°C increments upward (maximum +18°C) or downward (maximum -18°C), depending on which arrow key pad is pressed.

Failure Modes

All failure modes give a visual and audible alarm. When display shows FIO (internal fault), F30-F31(oven sensor circuit fault) or any F error codes, the electronic oven control has detected a fault condition. Note that code and push the _

V

pad to clean the display and stop the beeping. Reprogram the oven. If fault recurs, push _

pad, disconnect the

appliance to prevent damage and contact an authorized servicer.

 

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents 318203817 Rev. a Models, ModelosSears Roebuck and Co., Hoffman Estates, IL 60179 U.S.A Product Record Table of ContentsKenrnore Appliance Warranty Serial Plate LocationProperly installed anti=tip brackets provided with Proper Installation=Be sure your appliance is propInjury To persons could Result Install Stepping, leaning or sitting on the doorYour Oven Savethese Safety STR CTI U.S.A Master Protection AgreementsYour Electric Range Range featuresFeatures At a glance Selecting Surface Cooking Cookware Setting Surface ControlsFor best cooking results Setting Surface Controls Amount and type of food being cooked will influRecommended Rack Positions For BROIMNG, Baking & Roasting Before Setting Oven ControlsOven To Set the Clock Setting Oven ControlsOven Control Functions Broil PADSetting Oven Controls contd To Set the MinuteTimerIs up Baking ProblemsOven Baking information Broiling Tips ContdTo Broil Setting Oven Controls contd Failure ModesPorcelain Enamel General Care & CleaningCleaning Various Parts of Your Range Surfaces Cleaning Agents General Care & Cleaning contdPorcelain Enamel Cooktop Cleaning instructions INSTRUCTiONSTo Remove Oven Door To Raise theTop for CleaningRemoving and Replacing the Oven Door Possible. Regular Cleanings now will reduce the extent Porcelain Enamel Oven CleaningPrecautions Adhere toChanging Oven Light Storage DrawerRemoving and Replacing Storage Drawer DrawerEntire range or oven does not operate Solutions to Common ProblemsBefore you call Out of shape SolutionsProblems Oven light does not workCall anytime, day or night U.S.A. only 00-4-MY-H O MECall anytime, day or night U.S.A. and Canada Domicilio, y pare Ordenar piezas
Top Page Image Contents