Setting Warmer Drawer Controls contd, Self-Cleaning

Setting Warmer Drawer Controls (cont'd)

	occur and	result in	serious injury or death.
"'_i	Disconnect appliance		from electric power before
		Electrical Shock Hazard can

Left Glide

cleaning and servicing the warmer d rawer.

To Remove Warmer Drawer:

1. _	Turn poweroffbefore removing thewarmerdrawer.

2.Open the drawer to the fully opened position.

3.Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever (See Fig.l).

5.Pull the drawer away from the range.

To Replace Warmer (Warm & Ready TM) Drawer:

1.Pull the bearing glides to the front of the chassis glide

(See	Fig. 2).	Pu_hd .... ithfin_er
2. Align	the glide on each side of the drawer with the glide slots on	Fig. 1
the range.

3.Push the drawer into the range until levers "click" (approximately 2"). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers "click" or the bearing glides do

not feel seated	remove	the drawer and repeat steps 1 thru 3.	I _	Bo_*_a_e
This will minimize	possible	damage to the bearing glides.	__
			__}-J	Fig. 2

Self-Cleaning

Self=Cleaning Oven

A Self-Cleaning oven cleans itself with high temperatures (well above cooking temperatures) which eliminate soils completely or reduces them to a fine powdered ash you can wipe away with a damp cloth.

Adhere to the following cleaning precautions:

•DO NOT use oven cleaners or oven protective coatings in or around any part of the Self-Cleaning oven.

•DO NOT clean the oven door gasket. The woven material of the oven door gasket is essential for a good seal. Care should be taken not to rub, damage or remove the gasket.

•DO NOT use any cleaning materials on the oven door gasket. Doing so could cause damage.

•Remove the broiler pan and insert, all utensils and any aluminum foil. These items cannot withstand high cleaning temperatures.

•Oven racks should be removed. If they are not removed during the Self-Clean cycle their color will turn slightly blue and the finish will be dull. After the cycle is complete and the oven has cooled, rub the sides of the oven racks with wax paper or a cloth containing a small amount of salad oil (this will make the racks glide easier into the rack position).

•Remove any excessive spillovers in the oven cavity before starting the Self-Cleaning cycle. To clean, use hot, soapy water and a cloth. Large spillovers can cause heavy smoke or fire when subjected to high

temperatures. DO NOT allow food spills with a high sugar or acid content (such as milk, tomatoes, sauerkraut, fruit juices or pie filling) to remain on the surface as they may leave a dull spot even after cleaning.

Clean any soil from the oven frame, the door liner outside the oven door gasket and the small area at the front center of the oven bottom. These areas heat sufficiently to burn soil on. Clean with soap and water.

During the Self-Cleaning cycle, the outside of the range can become very hot to the touch. DO NOT leave small children unattended near the appliance.

The health of some birds is extremely sensitive to the fumes given off during the Self-Cleaning cycle of any range. Move birds to another well-ventilated room.

DO NOT line the oven walls, racks, bottom or any other part of the range with aluminum foil. Doing so will destroy heat distribution, produce poor baking results and cause permanent damage to the oven interior (aluminum foil will melt to the interior surface of the oven).

DO NOT force the oven door open. This can damage the automatic door locking system. Use caution when opening the door after the Self-Cleaning cycle is completed. The oven may still be VERY HOT.