ThisUse&CareGuideprovidesspecificoperating
instructionsforyourmodelUsethefreezeronlyas.
instructedinthisUse&CareGuideBeforestartingthe. freezer,followtheseimportant first steps.
iNSTALLATiON
•Choose a place that is near a grounded electrical outlet. Do Not use an extension cord or an adapter plug.
•For the most efficient operation, the freezer should be located where surrounding temperatures will not exceed 110°F (43°C). Temperatures of 32°F (0°C) and below will NOT affect freezer operation. Additional compressor heaters are not recommended.
•Allow space around the unit for good air circulation. Leave a 3 inch (75 mm) space on all sides of the freezer for adequate circulation.
3 =(75turn) Air Space
3" (75rnm)
Plastic
Leveling Feet
Crating
Screw
"". | Discard | Th | Crating ecrews |
And (2) Wood Bases
Unpacking and Leveling
To Level Chest Models:
If needed, add metal or wood shims between foot pads and floor.
CLEANING (PRIOR TO USE)
|
|
|
| Wash any removable parts, the freezer interior, and | ||||
|
|
|
| exterior with mild detergent and warm water. Wipe dry. | ||||
|
|
|
| Do not use harsh cleaners on these surfaces. | ||||
| (25ram) | • | Do not use razor blades or other sharp instruments, | |||||
|
|
| ||||||
Installation |
| Installation |
| which can scratch the appliance surface when | ||||
|
| removing adhesive labels. Any glue left from the tape | ||||||
|
|
|
| |||||
|
|
|
| can be removed with a mixture of warm water and mild | ||||
NOTE: The exterior | walls | of the freezer may become | quite | detergent, or touch the residue with the sticky side | ||||
warm as the compressor | works to transfer heat from | the | of tape already removed. Do not remove | the serial | ||||
inside. Temperatures | as much as 30° F warmer than room | plate. |
|
|
|
| ||
temperature can be expected. For this reason it is particu- |
|
|
|
|
| |||
larly important in hotter climates to allow enough space for |
|
|
|
|
| |||
air circulation around your freezer. |
| _To |
|
| allow door | to | ||
|
|
|
|
|
| |||
|
|
|
| close | and seal | properly, | DO NOT let | |
LEVELING |
|
|
| food | packages | extend | past the front |
|
|
|
|
| of shelves. |
|
|
| |
The freezer must have all bottom corners resting firmly on a solid floor. The floor must be strong enough to support a fully loaded freezer. NOTE: It is VERY iMPORTANT for your freezer to be level in order to function properly. If the freezer is not leveled during installation, the door may be misaligned and not close or seal properly, causing cooling, frost, or moisture problems.
To Level Upright Models:
After discarding crating screws and wood base, use a car- penter's level to level the freezer from
Shelf Front