Kenmore 790.4921 Before Setting Warmer Drawer Control, Arranging Warmer Drawer Rack Positions

Before Setting Warmer Drawer Control

Arranging Warmer Drawer Rack Positions

Set the warmer drawer rack in the vertical position as shown below.

The rack can be used in 2 ways:

•In the upright position to allow low profile food items to be placed both under and on top of the rack (for example, rolls or biscuits on top of the rack and a casserole dish under).

,,In the downward position for placement of light weight food items and empty dishware (for example, rolls or pastries and dinner plates).

Upright Position

Downward Position

Setting Warmer Drawer Control

To Operate the Warmer Drawer

The purpose of the warmer drawer is to keep hot cooked foods at serving tem- perature. Always start with hot food. It is not recommended to heat cold food in the warmer drawer.

All food placed	in the warmer	drawer should be covered	with a lid or aluminum foil	":"
to maintain moisture and softness. Do not cover crisp foods. Do not use plastic
wrap to cover	food. Plastic	may melt onto the drawer	and be very difficult to	_,'i,":
clean,				,ii:

Use only dishware, utensils and cookware recommended for oven use in the warmer drawer.

Always use potholders or oven mitts when removing food from the warmer drawer as cookware and plates will be hot.

Indicator Light

The indicator light is located below the thermostat control knob. It turns on when the control is set, and stays on until the control is turned off. Make sure indicator light is off when removing food from drawer.

	Warmer Drawer Humidity Controller	Feature
	This feature may be used to control humidity inthe Warmer Drawer.The control knob
	is located on the inner front panel of the Warmer Drawer.
	For dry heat: Slide the humidity control knob in the direction of less moist (.©)
		v
Figure 1	(Figure 1).This allows more of the moist heat to escape and provides a dryer environ-
	ment for the food inthe Warmer Drawer.

For moist heat: Slide the humidity control knob in the direction of more moist (:0_.) (Figure 2). This will help keep the food in the Warmer Drawer from drying out. Both heat and moisture will be applied to the Warmer Drawer cavity.

Figure 2