General Cleaning
Cleaning Various Parts of Your Appliance
Before cleaning any part of the warmer drawer, be sure all controls are turned OFF and the warmer drawer is COOL.
REMOVE SPILLOVERS AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANINGS NOW WILL REDUCE THE EXTENT AND DIFFICULTY OF MAJOR CLEANING LATER.
Surfaces | How to Clean |
|
Glass | You may use a glass cleaner on the outside | glass of the drawer. DO NOT |
Drawer Front Panel | immerse the drawer in water. DO NOT spray | or allow water or the glass cleaner |
| to enter behind the drawer glass panel. DO NOT use oven cleaners, cleaning | |
| powders or any harsh abrasive cleaning materials on the outside of the drawer. | |
Plastic
Control Knobs
Stainless Steel
Porcelain Enamel
Body Parts and Drawer Cavity
Warmer Drawer Rack
To remove control knob, turn to the OFF position; grasp firmly and pull straight off the shaft. Clean with a cloth soaked in soapy water. Rinse with a clean water and a dishcloth. To replace knob after cleaning, line up the flat sides of both the knob and the shaft; then push the knob into place.
Note: Humidity controller knob cannot be removed.
Clean stainless steel with hot, soapy water and a dishcloth. Rinse with clean water and a cloth. Do not use cleaners with high concentrations of chlorides or chlorines. Do not use harsh scrubbing cleaners. Only use kitchen cleaners that are especially made for cleaning stainless steel. Always be sure to rinse the cleaners from the surface as bluish stains may occur during heating that cannot
be removed.
...........ii
Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 1:1 solution of clear water and ammonia. If necessary, cover difficult spots with an
The rack may be removed for cleaning. If removed, clean by using a mild, abrasive cleaner following manufacturer's instructions. Rinse with clean water and dry.