Kenmore 665.16832 Canceling a Cycle, Changing a Cycle or Setting, After the first fill of a cycle

Use	this cycle for china		Use
and	crystal.	This cycle	covered
uses a light		wash and	detergent
gentle dry. During the			dispenser
heated dry, the heating			section.
element cycles on and off.
Initial display time: 68 min

Soil	Wash	Rinse	Main	Rinse	Final	Dry	Cycle	Water
Level			Wash	or	Heated		Time	Usage
Sensed				Purge	Rinse		(rain)	(gal/L}
	•		•	•	•	•	72*	8.6/32.7
Heavy					130°F	cycled
					(s4oc)
			•	•	•	•	58*	4.8/18.2
Light					130°F	cycled
					(s4oc)
		Use this	cycle	for pre-		Use
		rinsed or lightly-soiled				covered
		loads. The sensor adds				detergent
		water and time, if needed,				dispenser
		for maximum cleaning,				section.
		No drying options are
		available	for this cycle.
		Initial display time: 26 min
Soil	Wash	Rinse	Main	Purge	Final	Dry	Cycle	Water
Level			Wash		Heated		Time	Usage
Sensed					Rinse		(rain)	(gaUL)
	•		•	•	•		30*	s.g/26.t
Heavy					140°F
					(eooc)
Light			•	•	•		26"	€.8,'18.2
					140°F
					(6o°c)
		Use this rinse cycle for				Do not use
		rinsing dishes,		glasses,		detergent
		and silverware that will				with	this
		not be washed		right away,		cycle.
		Initial display time: 10 min
Soil	Wash	Rinse	Main	Rinse	Final	Dry	Cycle	Water
Level			Wash		Heated		Time	Usage
Sensed					Rinse		(min)	(gaUL)
		•		•			14	4.3/16.4
Heavy
				•			10	2.2/8.2
Light

NOTE: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary from the numbers above as the sensor adjusts the cycle for the best wash performance.

Canceling a Cycle

Anytime during a cycle, press

The dishwasher pauses for about 5 seconds. Then the display shows

Your dishwasher starts a 2 minute drain (if needed). Let the

dishwasher drain completely. The light turns off after 2 minutes.

NOTE: If your dishwasher does not need draining, the light turns off. Select a new cycle and options.

To stop the drain

You can press Cancel/Drain again to stop the drain immediately. Remember to drain the dishwasher before starting a new cycle.

NOTE: A small amount of water remains in the dishwasher. This is normal.

To clear the indicators

Press Cancel/Drain before starting the dishwasher to clear all options and cycles.

Changing a Cycle or Setting

During the first fill of a cycle

1.Press a new cycle and/or options.

2, Check the detergent dispensers. They must be filled properly for the new cycle.

After the first fill of a cycle

1.Press

The display shows

Your dishwasher starts a 2 minute drain (if needed). Let the

dishwasher drain completely. The light turns off after 2 minutes.

NOTE: If your dishwasher does not need draining, the light turns off.

2, Check the detergent dispensers. They must be filled properly for the new cycle.

3, Close the door.

4.Press a new cycle and/or options.

5.Press START.

14