Kenmore 665.16839, 665.16837 manual Adding Items During a Cycle, Option Selections, To add items

Adding Items During a Cycle

You can add an item anytime before the main wash starts. Open the door and check the detergent dispenser. If the main wash section is still closed, you can add items.

To add items

1.Lift up the door latch to stop the cycle. Wait for the spraying action to stop before opening the door.

2.Open the door. If the main wash detergent dispenser is still closed, add the item.

3.Close the door, but do not latch it. Wait 30 seconds for the air in the dishwasher to warm up. This reduces the amount of moisture escaping from the vent when restarting a Cycle.

4.Close the door firmly until it latches. The dishwasher resumes the cycle after about a 5 second pause.

Option Selections

You can customize your cycles by pressing an option. If you change your mind, press the option again to turn the option off. Select a different option if desired.

You can change an option anytime before the selected option begins. For example, you can press an unheated drying option any time before drying begins.

Press START to use the same cycle and option(s) as the previous wash cycle.

NOTE: If the last cycle you completed was a rinse cycle, when

you press Start, the dishwasher runs the last full wash cycle and options.

Hi Temp Scrub

Select this option to heat the water during parts of the cycle. Hi Temp Scrub heats the water to 145°F (63°C) in the main wash. Heating the water helps improve washing results. Hi Temp Scrub is useful when loads contain baked-on food.

This option adds heat, water and wash time to the cycle.

NOTE: Hi Temp Scrub is an option with the Anti Bacterial, Pots Pans and Normal Wash cycles.

Sani Rinse

Select this option to raise the water temperature in the final rinse to approximately 155°F (68°C) for 10 minutes, Sani Rinse adds heat and time to the cycle, In the Normal cycle this high- temperature rinse sanitizes your dishes and glassware in accordance with the NSF Protocol P153 Sanitization and Cleaning Performance of Household Spray-Type Dishwashers,

NOTE: Anti Bacterial automatically uses this option. Sani Rinse is

an option with Pots Pans, Normal Wash and China Gentle.

Air Dry

Select this energy-saving option to dry without heat. Air drying is useful when loads contain plastic dinnerware that may be

sensitive to high temperatures,

Q

LOCKON

The dishes take longer to dry and some spotting can occur. For

best drying, use a liquid rinse aid. Some items (such as plastics) may need towel drying.

NOTE: Time Saver and Quick Rinse automatically use this option. Air Dry is an option with all other cycles.

Lock On

Use the Lock to prevent your dishwasher from accidentally being

turned on. Use the Lock, also, to prevent accidental cycle or option changes during a cycle.

@

LOCKON

When LOCK ON is lit, all buttons are disabled.

NOTES:

•The dishwasher door can be opened while the contrels are locked.

•You can turn on the Lock while the dishwasher is running.

To turn on the Lock

Press and hold

LOCKON

for 4 seconds. LOCK ON glows.

If you press any pad while your dishwasher is locked, the light flashes 3 times.

To turn off the Lock

Press and hold AIR DRY for 4 seconds. The light turns off.

Delay Hours

Select this option to run your dishwasher at a later time or during off-peak hours. You can add items to the load anytime during the delay countdown. After adding items, close the door firmly until it latches. The delay countdown will not continue if the door is not latched.

•You can delay the start of a cycle up to 12 hours.

•The first time you use Delay Hours, you will see

showing a 1 hour delay.

15