Kenmore 630.7793 manual Depending on the hardness of water, adjust the rinse agent

Problem	Cause		Action
Odor	1.	Food debris is present at the bottom of the dish-	1.	Remove the filters and clean according to the “Check/
		washer.		Clean the Filter System” section of this manual.
	2.	Food particles are present near the door seal.	2.	Refer to “Clean the Door Gasket and Door Seal” in the
	3.	Dishes left too long in unit before running a cy-		Care and Maintenance section of this manual .
		cle.	3.	Run a Quick Rinse cycle if you do not intend to immedi-
	4.	Residual water is present at the bottom of the		ately wash the dishes.
		dishwasher.	4.	Ensure the unit has completely drained from the last cy-
	5.	Drain hose is obstructed.		cle. Refer to the “Canceling or changing the cycle” sec-
				tion of this manual.
			5.	Remove any obstructions from the drain hose by calling
				qualified personnel.
			If odor still persists, run the Normal/Regular cycle until it flush-
			es, then open the door to interrupt the cycle, and place an
			8 oz. cup of distilled white vinegar solution on the top rack.
			Close the door and allow the cycle to finish.
Dishwasher not	1.	Restriction in the water supply system.	1.	Ensure that the water supply valve (typically located under
filling with water	2.	Previous wash cycle was not completed.		kitchen sink) is open and check that the water supply line
	3.	Delay-start is active.		has no kinks and clogs.
			2.	Refer to the “Canceling or changing the cycle” section of
				this manual.
			3.	Cancel the delay-start or wait until delay-start time com-
				pletes (times out). Refer to the “Delay Start” section of
				this manual.
Water Leaks	1.	Suds	1.	Wrong type of detergent results in suds and leaks. Use
	2.	Door seal could be pulled away from track.		only dishwasher detergents. If suds still persist, then add
	3.	Condensation vent is blocked.		one tablespoon of vegetable oil at the bottom of the
	4.	Improper installation.		dishwasher and run the desired cycle.
			2.	Ensure that door seal is in the track.
			3.	Ensure that condensation vent is not blocked. Refer to
				“Loading Extra Tall Items” in the Preparing and Loading
				the Dishwasher section of this manual.
			4.	Have proper installation verified by qualified personnel
				(water supply, drain system, leveling, plumbing).
Tub stains	1.	Stains on the dishwasher interior are due to	1.	Concentrated Lemon juice can reduce the build up of
		hardness of water.		hard water stains. Run a normal cycle until it flushes and
	2.	Silverware in contact with tub.		interrupt the cycle and then place an 8 oz. cup of the
				concentrated lemon solution on the top rack and finish the
				cycle. This can be done periodically to avoid build up.
			2.	Ensure that the silverware does not make contact with the
				tub while running a cycle.
Streaks on	Incorrect rinse agent setting.		Depending on the hardness of water, adjust the rinse agent
glassware or			dispenser. Refer to “Adding Detergent and Rinse Agent” sec-
residue on the			tion in this manual for adjustment.
dishes
Fascia panel	Abrasive cleaner used.		Use mild detergents with soft damp cloth.
discolored or
marked
Noise during	The dishes may not be arranged properly.		Water circulation sound is normal, but if you suspect items are
wash cycle			banging into each other or into the spray arms, refer to the
			“Preparing and Loading” section of this manual for optimal
			arrangement.
Detergent	1.	Improper operation of detergent cover.	1.	Refer to “Adding Detergent and Rinse Aid” section of
dispenser cover	2.	Previous cycle has not been finished, reset, or		this manual for instructions on opening and closing the
will not shut		cycle was interrupted.		dispenser.
			2.	Refer to “Canceling a cycle” and “Changing a cycle”
				information in the Operating the Dishwasher section of
				this Use & Care Guide
Unable to select	Previous cycle has not finished.		Refer to “Canceling a cycle” and “Changing a cycle” infor-
desired cycle			mation in the Operating the Dishwasher section of this Use &
			Care Guide.

18