Assembling the Turntable
up with
the Mc- Intosh
MCC10 Car-
tridge postion marking on the
suface. Refer to
figure 13. Then
tighten the knurled knob to secure the position of the Coun- ter Weight.
9.Locate the Tone Arm Height Gauge (used for the McIntosh MCC10 Cartridge) from inside the accessory box.
10.The gauge should just fit between the Tone Arm Hous- ing and the Mounting Plate of the Tone Arm. This will
verify the preset Tone Arm Height has not changed during ship- ping. Refer to figure
14.If the space has changed, carefully loosen the Tone Arm Height Set Screw in the Mounting Plate and adjust the height
of the Tone Arm so the gauge will just fit.
Note: Do not rotate the Tone Arm
Horizontally when making the vertical height adjust- ment.
11.Place the McIntosh MT10 Turntable in its operation location. Notes: 1. To reduce the chance of acoustic feedback lo-
cate the turntable the greatest possible distance from the system loudspeakers.
2.To minimize the possibility of the cartridge sty- lus jumping record grooves, place the turntable on a mechanically stable surface such as wall shelving anchored to wall studs.
12.Remove the protective film from the Optical Sensor located on the Turntable Top
Surface. Refer to | Remove Film |
figure 15. |
|
Figure 15
13.Remove the protec- tive film from the botton of the Turn- table Platter cover the Optical Ring. Refer to figure 16.
14.Remove the protec- tive foil from the bot- ton of the Turntable Vertical Bearing opening. Refer to figure 17.
15.Locate the supplied Turntable Bearing Oil and place two small drops of Oil on the top sides of the Vertical Bearing Ceramic Shaft.
16.Very carefully center the Vertical Bearing Ceramic Shaft with the Vertical Bearing opening on the bot- tom of the Turntable Platter. Lower the Platter onto the Ceramic Shaft while keeping the platter parallel with the top surface of the Turntable. Refer to figures 18, 19 and 20.
17.Using the supplied cloth gloves place the belt onto the circumference of the platter and then onto the pulley of the mo- tor. Rotate the plat- ter by hand while seating the belt into the recessed groove on the platter.
18.Locate the Turntable Platter Mat and place it on top of the platter.
Remove Film Figure 16
Remove Film
Figure 17
Figure 18
Figure 19
Figure 20
9
