Sani Rinse
Select this option to raise the water temperature in the final rinse to approximately 155°F (68°C). Sani Rinse adds heat and time to the cycle. This high temperature rinse sanitizes your dishes and glassware in accordance with NSF/ANSI Standard 184 for Residential Dishwashers. Certified residential dishwashers are not intended for licensed food establishments.
NOTE: Sani Rinse is an option with SMART WASH™, Pots Pans, and Normal Wash cycles. Only these sanitization cycles have been designed to meet the NSF/ANSI requirements.
Heated Dry
The Heated Dry option in combination with rinse aid will give you excellent drying results. The energy to use Heated Dry costs pennies per cycle. Heated Dry is on when the light is lit on the Heated Dry button. Be sure to load plastic items in the upper rack to avoid damage.
You may turn off the Heated Dry option by pressing HEATED DRY so that the light goes off. However, you will have items in your dishload that will not be dry at the end of the cycle.
NOTE: The Heated Dry option is used in all cycles except Fast Wash and Quick Rinse.
Lock On
Use the Lock On to prevent unintended use of the dishwasher between cycles.
When Lock On is lit, all buttons are disabled.
NOTE: The dishwasher door can be opened while the controls are locked.
To turn on the Lock
Press and hold HEATED DRY for 4 seconds. Lock On glows.
If you press any pad while your dishwasher is locked, the light flashes 3 times.
NOTE: If the Heated Dry option is selected, the light will temporarily turn off until Lock On glows.
To turn off the Lock
Press and hold HEATED DRY for 4 seconds. The light turns off.
4 Hour Delay
Select this option to run your dishwasher at a later time or during
To delay the start
1.Press the delay button to choose the number of hours delayed.
2.Select a wash cycle and options.
3.Press START/RESUME.
The dishwasher starts the cycle in the selected number of hours.
NOTES:
■To cancel the delay and cycle, press CANCEL/DRAIN.
■To cancel the delay and start the cycle, press START/ RESUME.
■If the door is not closed within 3 seconds of pressing Start/ Resume, press START/RESUME again.
Cycle Status Indicators
Follow the progress of your dishwasher with the Cycle Status indicators.
Clean
Clean glows when a cycle is finished. The light turns off when you press any button or close the door.
Sanitized
If you select the Sani Rinse option, Sanitized glows when the Sani Rinse cycle is finished. If your dishwasher did not properly sanitize your dishes, the light flashes at the end of the cycle. This can happen if the cycle is interrupted or the incoming water temperature is too low. The light turns off when you press any button or close the door.
Active Vent
The active vent reduces the filling and washing sounds from your dishwasher. The vent closes, after the cycle starts, to lock in sound. After the cycle finishes and the dishes cool for several hours, the vent opens. This keeps any water vapor from collecting on the countertop. Between cycles, the vent stays open for airflow, reducing the buildup of odors.
NOTE: There is a slight noise when the vent closes or opens. This is normal.
Overfill Protection Float
The overfill protection float (in the front right corner of the dishwasher tub) keeps the dishwasher from overfilling. It must be in place for the dishwasher to operate.
Check under the float for objects that may keep the protector from moving up or down.
17