RinseAgent
To achieve proper drying, always use a liquid rinse agent, even if your detergent contains a rinse agent or drying additive.
NOTE: The dishwasher indicates low rinse agent by showing
the _g_ symbol in the countdown display. Units without a
4A'_
display have a Rinse Agent LED that illuminates when the Rinse Agent is low.
NOTE: The LED will not illuminate if there is enough rinse agent in the dishwasher.
Adding Rinse Agent
!
Always use Rinse Agent even if your detergent contains rinse agent.
Add rinse agent when the LED on the control panel illuminates.
Filling the dispenser
*Make sure the dishwasher door is completely open.
oTo fill the dispenser with rinse agent, simply pour on the "arrow'as shown below until the rinse agent is visibly full.
Wipe up any excess rinse agent that puddles when the dispenser reservoir is full to prevent sudsing.
After filling the rinse agent dispenser, the indicator light will go out in a few minutes after the dishwasher door is shut.
Rinse Agent Setting
The default factory setting for the rinse agent is set between 3 and 4.
If you notice spots on glasses, it means you need more rinse agent.
If you notice streaks, it means you need less rinse agent.
To Decrease | To Decrease |
Streaks on glasses | Spots on glasses |
To adjust the amount of rinse agent dispensed:
. Turn the dial (in the shape of an arrow) until you reach the desired level between 1 and 6.
12