Connecting the faucet adapter to faucets with internal threads
Insert the 2 screens, the thin washer, and then the thick washer from the faucet adapter kit into the faucet adapter. Attach the adapter onto the end of the faucet.
1
2
4
1.Thick washer
2.Thin washer
3.Screens
4.Faucet adapter
NOTE: Use both washers.
1.Run water at the faucet until it is hot. Turn the water off.
2.Pull the hoses out of their storage compartment on the back of the dishwasher.
NOTE: Make sure the hoses are not kinked or twisted. Kinked hoses reduce washing performance.
3.Pull down on the locking collar while lifting the hose connector onto the faucet adapter.
3
1.Faucet adapter
2.Locking collar
3.Hose connector
4.When the connector snaps into place, release the locking collar.
5.Turn the hot water on slowly until it is all the way on.
6.Plug into a grounded 3 prong outlet.
You can draw water from the faucet while the dishwasher is connected.
NOTE: Do not draw water while the dishwasher is filling or while water is being pumped out. (This helps prevent a low fill when dishwasher is filling or mixing drain water with fresh water when dishwasher is draining.)
Press the red button on the hose connector to draw water from the faucet. (The faucet is set on hot. Adjust the faucet for the water temperature you want.)
NOTE: Turn the hot water back on after you draw water from the faucet. Turn off the cold water.
1.Turn the hot water off. (This can be done after the last rinse.)
2.Press the red button on the connector to release the water pressure.
3
4
1.Faucet adapter
2.Locking collar
3.Red button
4, Hose connector
3.Lift slightly on the hose connector while pulling down the locking collar. Pull down on the connector.
4.Empty any remaining water from the connector by turning the connector
5.Unplug the power supply cord and return it to the storage compartment.
6.Return the hoses to the storage compartment.
9