Kenmore 790.4139, 318205128 manual Before You Call, Solutions to Common Problems

Page 22

Before You Call

Solutions to Common Problems

Before you call for service, review this list. it may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance.

OCCURRENCE

Oven Control Beeps and Displays any F code error (example Fll).

d-O is displayed.

Range not level.

Poor baking results.

Entire oven does not operate.

Oven light does not work.

Fan noise during cooking operation,

POSSIBLE CAUSE/SOLUTION

Electronic control has detected a fault condition. Press STOP/CLEAR to clear the display and stop beeping. Reprogram the oven. If a fault reoccurs, record

the fault number. Press STOP/CLEAR and call Sears or another qualified servicer.

The door was left open and controls set for self-cleaning cycle. Close the door.

Place oven rack in center of oven. Place a level on the oven rack. Contact installing agent if rack and cabinet cutout flooring are not level.

Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets are square and level. Contact cabinet maker to correct problem.

When the oven is first plugged in, or when the power supply to the oven has

been interrupted, the display will flash. The oven cannot be programmed until the clock is set.

Be sure electrical cord is securely connected into the electrical junction box.

Cord/plug is not installed and/or connected. Cord is not supplied with oven. Contact Sears or another qualified servicer.

Service wiring not complete. Contact Sears or another qualified servicer.

Power outage. Check house lights to be sure. Call your local electric company.

Short in cord/plug. Replace cord/plug.

Controls are not set properly. See instructions under Setting Oven Controls to set the controls.

House fuse has blown or circuit breaker has tripped immediately following installation. House fuse may not be fully engaged. Check fuse and screw or engage circuit breaker securely.

House fuse has blown or circuit breaker has tripped after the oven has been installed and previously operating. Call Sears or another qualified servicer.

Burned-out or loose bulb. Follow the instructions under Changing Oven Light to replace or tighten the bulb.

A cooling fan may automatically turn on and off to cool internal parts. This is normal, and the fan may continue to run even after oven is turned off.

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Sears Roebuck and Co., Hoffman Estates, IL 60179 U.S.A 318205128 Rev. aProduct Record Serial Plate Kenmore Appliance WarrantyLocation Save these instructions for future reference Read all instructions before using this applianceProper Installation. Be sure your appliance is = All wall ovens can tipInstructions for cleaning Your OvenMaster Protection Agreements Acuerdos maestros de protecci6nWall Oven FeaturesYour Electric At a GlanceArranging LocationOven Racks For a silent control panel Control Pad FeaturesTemperature ConversionTo Set Add 1 Minute Feature Setting the ClockTo Set the Minute Timer To Set the ClockTo Set Control for Continuous Bake or 12 Hour Energy Saving To Set Control for Oven LockoutTo Set the Timed Bake and Delay Start Features Press@ andholdfor3secondsandLocwillappearinthedisplayOven Baking Broiler Pan Broiler Clean-Up Tips some modelsGrid Some Models PreheatingTo set Warm & Hold Setting Oven ControlsSetting the Warm & Hold TM Feature To Operate the Oven LightsSetting Oven Controls Self-Cleaning upperovenonly Adhere to the following cleaning precautionsSelf-Clean Cycle time length What to Expect during CleaningStopping or Interrupting a Self=Cleaning Cycle General Care & Cleaning PartsCare and Cleaning of Stainless Steel somemodels Geleverhook Removing and Replacing the Oven Door Adjusting the Oven Temperature To Adjust Oven TemperatureSolutions to Common Problems Before You CallPossible Page Page Call anytime, day or nightU.S.A, and Canada MY-HOMEOur Home Call anytime, day or night
Top Page Image Contents