CONTROLS AND CONNECTIONS
Master Output Section
• Master Output Fader | Changes the selected output’s audio level |
| |
| Move the Master Fader up and down to increase and |
| decrease the level of the selected output’s audio. |
| The dB value of boost or attenuation is displayed below the |
| Channel Fader from |
| Two virtual LED meters to the right of the Master Fader |
| display the pre fader levels of the audio signal. |
| The peak value in dBFS of the channel’s audio is displayed |
| directly above the Master Output’s virtual LED meter. |
| NOTE: If the peak values display “CLIP”, then your |
| Mixer channels and/or your DAW playback levels |
| should be reduced. The clip indicators clear when |
| the mouse pointer hovers over them. |
|
|
• Master Mute and Solo Clear |
|
| Clears all active channel Mutes or Solos |
| The Master Mute and Solo clear buttons are only active |
| when a channel’s mute or solo button is active. |
|
|
3.1.3 FireControl Mixer
The FireControl Mixer allows you to create a customized mix of up to 18 of the FireStudio Project’s hardware inputs and software playback outputs and adjust their levels independently for each of the FireStudio Project’s stereo output pairs with zero latency. The Mixer section is only visible if the selected output pair’s Mixer Toggle is on.
NOTE: The Mixer is common to all of the FireStudio Project’s outputs, so if you add or remove a channel from the Mixer, every output with the Mixer Toggle on will be affected by the change.
18 PreSonus 2007