iCE AND WATER DISPENSER FEATURES
The ice and water dispenser convenbntUy dispenses chHbd water, and ice cubes or crushed ice, depending on the model
To operate the ice dispenser, sebct the ice option desired using the touchpad. Press a gUassagainst the dispensing paddb as far up as possibb to catch aH ice. To stop dispensing ice, pull gUassaway from dispensing paddb. Do not remove the gUassuntil the ice has compbteUy dispensed. (Compbte instructions for the dispenser operation are attached to the inside of the freezer door.)
The ice maker produces 4 to 6 pounds of ice every 24 hours depending on usage conditions, ice is produced at a rate of 8 cubes every 75 to 90 minutes.
How the Water Dispenser Works
The water tank located behind the drawers in the refrigerator compartment, automatically fills as water is dispensed. For proper dispenser operation, the recommended supply water pressure should fall between 20 psi and 100 psi,
Water pressure must not exceed !00 Ibs, Excessive pressure may cause water filter to malfunction,
After the refrigerator is connected to the water supply, fill the water tank by drawing one glass of water, it may take about 11/2minutes after activating the dispenser paddle before water begins to fill this first glass. Continue flushing the system for 3 minutes to rid the tank and plumbing connections of any impurities. The water dispenser has a built in shutoff device that will stop the water flow after 3 minutes of continuous use. Simply release the dispenser paddle to reset the shutoff mechanism.
Chemicals from a maffunctioning softener can damage the ice maker. If the ice maker is connected to soft water, ensure that the softener is mai rltained and working properly.
How the ice Dispenser Works
The ice maker and container are located in the top of the freezer compartment. After the refrigerator is installed properly and has cooled for several hours, the ice maker can begin making ice within 24 hours. Air in new plumbing lines may cause the ice maker to cycle two or three times before making a full tray of ice. ice production is controlled by the ice maker'sOn/Off power switch. Press the switch to the "0" position to turn it Off and press it to the '1"position to turn it On. With no usage it will take approximately 2 days to fill the ice container. The ice maker also has a
production when the ice bin is full. This signal arm should not be used to manually stop the ice maker.
Because of new plumbing connections, the first production of ice cubes may be discolored or have an odd flavor, These should be discarded until the cubes made are free of discoloration and taste,
iCE DISPENSER TiPS
ice cubes stored too long may develop an odd flavor. Empty the ice container and ensure that the ice maker'sOn/Off power switch is turned On (set to the '1"position). The ice maker will then produce more ice.
oOccasionally shake the ice container to keep ice separated.
oKeep the ice maker'sOn/Off power switch turned Off (set to the "0" position) until the refrigerator is connected to the water supply or whenever the water supply is turned off.
iMPORTANT: The ice maker !s tureed On at the factory SOit can work as soon as you insta!!your refrigerator. If you cannot Connect a water supply, turn the On/Off switch tOthe Off ('{011)position_Otherwise, the ice maker'svalve may be n°isY who n it attemp!s to operate witho ut water:
the disport!!rig paddle !S pushed for more tha n 4 m!nutes, the dispenser motor may ovedoad and stop.The overload protector will reset automatically after 3 or 4 minutes.
14