Kenmore 795.785 manual Unpacking Your Refrigerator, Next, Excessive Weight Hazard

Page 8

Excessive Weight Hazard

Use two or more people to move and install refrigerator.

Failure to do so can result in back or other injury.

UNPACKING YOUR REFRIGERATOR

Remove tape and any temporary labels from your refrigerator before using. Do not remove any warning-type labels, the model and serial number label, or the TechSheet that is attached to back wall of the refrigerator.

To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.

Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your refrigerator. For more information, see the important Safety instructions section.

Refrigerator shelves are installed in the shipping position.

Please reinstall shelves according to your individual storage needs.

When Moving Your Refrigerator:

Your refrigerator is heavy. When moving the refrigerator for cleaning or service, be sure to protect the floor. Always pull the refrigerator straight out when moving it. Do not wiggle or walk the refrigerator when trying to move it, as floor damage could occur.

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from refrigerator.

Failure to do so can result in death, explosion, or fire.

•To reduce the risk of electric shock, do not install the refrigerator in a wet or damp area.

•Select a place where a water supply can be easily connected for the automatic icemaker.

_. CAUTION: Avoid placing the unit near heat sources, direct sunlight or moisture.

iNSTALLATiON

•To minimize noise and vibration, the refrigerator MUST be installed on a solidly constructed floor.

•Carpeting and soft tile surfaces are not recommended.

•Never install the refrigerator on a platform or weakly supported structure.

1.To avoid vibration, the unit must be leveled. If required, adjust the leveling legs to compensate for unevenness of the floor. The front should be slightly higher than the

rear to aid in door closing. Leveling legs can be turned easily by tipping the cabinet slightly. Turn the leveling

legs clockwise (_) to raise the unit, counterclockwise ( _,,..L) to lower it.

2.Install this appliance in an area where the temperature is between 55°F (13°C) and 110°F (43°C.) tf the temperature around the appliance is too low or high, cooling ability may be adversely affected.

3.Too small a distance from adjacent items may result in lowered freezing capability and increased electricity consumption charges. Allow at least 24 in. (61 cm) in front of the refrigerator to open the doors.

.

,

,7

I-md

1" (2.54 cm)

NEXT

1.Clean your refrigerator thoroughly and wipe off all dust accumulated during shipping.

2.Install accessories such as ice cube bin, drawers, shelves, etc., in their proper places. They are packed together to prevent possible damage during shipment.

3.Let your refrigerator run for at least 2 or 3 hours before putting food in it. Check the flow of cold air in the freezer compartment to ensure proper cooling. Your refrigerator is now ready for use.

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Congclateur Infcrieur Rcfrigcrateur Models / Modelos / Modeles 795.7850English Version Disclaimer of implied warranties limitation of remedies One Year Limited WarrantyFive Year Limited Warranty on Sealed Refrigeration System Master Protection Agreements Basic Safety Precautions To Connect Electricity Recommended Grounding MethodBefore YOU Throw Away Your OLD Refrigerator Or Freezer USE of Extension CordsBin Excessive Weight Hazard When Moving Your RefrigeratorUnpacking Your Refrigerator NextRemoving Freezer Drawer Handle HOW to Remove Door HandlesRemoving Refrigerator Handle Reinstalling the Freezer Drawer Handle HOW to Replace Door HandlesReinstalling the Refrigerator Door Handle Removing and Replacing Refrigerator Doors To remove the left refrigerator doorCorrect Incorrect Reinstalling the Refrigerator Door Right DoorLeft Door HOW to Remove and Install Pullout Drawer Removing Pullout DrawerInstalling Pullout Drawer Door Alignment Leveling and Door AlignmentLeveling Setting the Controls Ensuring Proper AIR CirculationIN=DOOR iCE Bank Adjusting Control Settings Food Storage GuideItems MilkStoring Frozen Food Water DispenserDo not use FreezingRefrigerator Shelves Bottle Holder 795.7851 Model OnlySnack PAN Crisper Humidity ControlModular Door BIN Dairy BINHow to use Tilting DoorExtra ICE BIN TILT-OUT Door BasketPull OUT Drawer DurabaseDurabase Divider Replace with a new cartridge FilterRemove the old cartridge General Cleaning Tips Light Bulb ReplacementOutside Door Liners and GasketsPower Interruptions When YOU GO on VacationWhen YOU Move If you choose to leave the refrigerator on while youAutomatic Icemaker Personal Injury HazardNormal Sounds YOU MAY Hear Preparing for VacationBefore YOU Begin What YOU will NeedShut OFF the Main Water Supply Choose the Valve LocationFasten the Shutoff Valve Tighten the Pipe ClampConnect the Tubing to the Valve Flush OUT the TubingConnect the Tubing to the Refrigerator Turn the Water on AT the Shutoff ValvePlug in the Refrigerator Start the IcemakerUnderstanding Sounds YOU MAY Hear Refrigerator does not OperateVibration or Rattling Noise Lights do not WorkCompressor Motor Seems to RUN TOO Much Doors will not Close CompletelyFrost or ICE Crystals on Frozen Food ThenICE has OFF-TASTE or Odor There is Water in the Defrost Drain PANCubes Produced by Iceimiaker are TOO Smiall Check if ThenDoors are Difficult to Open Checkif ThenYou r Ho m e =800=LE.FOYERMC

795.785 specifications

The Kenmore 795.785 is a sophisticated French door refrigerator that combines style, efficiency, and innovative technology to enhance the modern kitchen. With its sleek stainless-steel finish and spacious interior, this refrigerator is designed to seamlessly blend with contemporary kitchen decor while providing ample storage for various food items.

One of the standout features of the Kenmore 795.785 is its advanced cooling system, which utilizes a multi-air flow technology. This system ensures that cool air is evenly distributed throughout the refrigerator compartments, maintaining a consistent temperature and extending the freshness of your groceries. The adjustable shelves and door bins offer versatility in storage, allowing users to accommodate larger items or organize smaller groceries efficiently.

The refrigerator also comes equipped with a convenient water and ice dispensing system. This feature provides easy access to chilled filtered water and ice, promoting a healthy lifestyle and reducing the need for bottled beverages. The ice maker is situated in the freezer compartment, ensuring that the main refrigeration area remains spacious and clutter-free.

Another noteworthy characteristic of the Kenmore 795.785 is its energy efficiency. This model is designed to meet ENERGY STAR standards, indicating that it consumes less energy while delivering optimal performance. As a result, users can expect lower electricity bills without sacrificing functionality or convenience.

Smart technology enhances the functionality of the Kenmore 795.785, as it features Wi-Fi connectivity that allows homeowners to monitor and control the refrigerator remotely. Through a dedicated mobile app, users can receive alerts about door openings, temperature fluctuations, and even filter replacement reminders. This level of connectivity empowers users to manage their appliance more effectively, promoting peace of mind.

The sleek interior is complemented by LED lighting, which illuminates every corner of the refrigerator, making it easy to locate items. Additionally, the metal cooling system helps in retaining maximum temperature and humidity levels, further ensuring that food stays fresher for longer.

In summary, the Kenmore 795.785 is a feature-rich French door refrigerator that meets the needs of modern consumers. With its advanced cooling technology, spacious design, energy efficiency, and smart features, this model stands out as an ideal choice for anyone seeking a reliable and stylish refrigeration solution.
Top Page Image Contents