Installation
Pullout Freezer Drawer
To prevent accidental child entrapment or
suffocation risk, do not remove the divider in the top freezer basket.
To avoid electrical shock which can cause severe personal injury or death, disconnect power to refrigerator before removing doors. After replacing doors, connect power.
To avoid possible injury, product, or property damage, you will need two people to perform the following instructions.
To Remove:
1.Pull upper basket out to full extension and lift out to remove.
2.Pull drawer open to full extension.
3.Lift lower basket straight up and out to remove.
4.On each side rail is a basket cradle with two
snap attachments. To release each cradle, unlatch the snaps by pushing them inward, away from the side rail system. Lift the cradles off of the rails.
5.Lift top of drawer front to unhook supports
from rail system. Lift door front out to
remove.
To Install:
1.Pull both rails out to full extension.
2.While supporting door front, hook supports into tabs located on inside of rail.
3.Lower door front into final position.
4.Place the basket cradles back onto the side rails. Align snaps with the slots on the side rails and press each snap towards the rail until it clicks.
5.With rails pulled out to full extension, set the basket straight down into the basket cradles.
Basket cradle
snap attachments
6.Slide upper basket into freezer. Make sure that rear of basket hooks behind rail catch.