Ice

Troubleshooting

Refrigerator is	• Plastic tubing was used to complete
leaking water	water connection.

• Improper saddle valve was installed.

(ce forms in	inlet	• Water pressure is too low.
tube to ice	maker

The manufacturer recommends using copper tubing for installation. Plastic is less durable and can cause

leakage. Sears is not responsible for property

damage due to improper installation or water connection.

Check water connection procedure (see page 12).

Self-piercing and 3/,_saddle.. valves cause low water pressure and may clog the line over time. Sears is

not responsible for property damage due to improper installation or water connection.

Water pressure must be between 35 to 100 pounds per square inch to function properly, A minimum pressure of 35 pounds per square inch is recommended for refrigerators with water filters,

• Freezer temperature is too high.

Water	flow	is	• Water pressure is too low.
smower	than	normal

•Adjust freezer control (see page 14:).Freezer is recommended to be approximately 0° F (-18° C).

Water pressure must be between 35 to 100 pounds per square inch to function properly. A minimum pressure of 35 pounds per square inch is recommended for refrigerators with water filters.

• Improper saddle valve was installed.

• Copper tubing has kinks.

Check water connection procedure in your Installation Instructions. Self-piercing and 3/,_saddle.. valves cause low water pressure and may clog tile line over time. Sears is not responsible for

property damage due to improper installation

or water connection. Open water valve completely and check for leaks.

•Turn off water supply and remove kinks. If kinks cannot be removed, replace tubing.