TOREPLACEWATER FILTER:
,,It is not necessary to turn the water supply off to change the filter. Push the filter release button, located to the right of the filter cartridge, to release the filter from the housing. To minimize the possibility of the filter falling out of the housing during removal, it would be best to hold the filter as it moves out toward you. NOTE: A small amount of water may be released during this operation. You should have a paper towel or dish cloth handy to wipe out any water that may drip out of the filter or housing. Two small holes near the back of the housing have been added for any excess water to escape. It would be best to clear away any food near this area on the top shelf in advance of removing the filter.
,,Pull the old filter cartridge straight out of the housing and discard it.
,,Then follow the instructions above for installing a water filter.
ADJUSTABLE DOOR BINS
This model is equipped with adjustable door bins that can be moved to suit individual needs.
TO MOVE DOOR BINS:
,,Lift the bin straight up.
,,Remove the bin.
,,Place the bin in desired position.
,,Lower the bin onto supports until locked in place.
FULLWIDTH GALLON BIN
Filter
Slide
Out to
Remove
The full width gallon bin is especially designed to hold gallon- sized containers like milk gallons.
Order new filter cartridges through the dealer where you bought the refrigerator, or contact the Sears PartsDirect at
with the PureSource2 TM cartridge FC 100 is tested
and certified by NSF international, the nationally
(_The PureSource2 TM Water Filter System NGFC 2000 recognized and respected, not for profit, certification
organization for public health safety.
The PureSource2 TM Filter System is tested and certified to ANSI/ NSF Standards 42 and 53. See performance data sheets for specifications. This system should not be used on water that is microbiologically unsafe or with water of unknown quality unless the water has been adequately disinfected before or after traveling through the filtration system.
TALL BOTTLE RETAINER / BIN SNUGGER
The tall bottle retainer keeps all containers in the bin from falling forward when opening or closing the refrigerator door. To install, hold the retainer or snugger at the top, and slide it over the outside wall of the bin.
,, | Rated | Capacity: | 400 gallons | |
,, | Rated | Service Flow: | .5 GPM | |
,, Maximum | Rated Pressure: | 100 PSI | ||
,, | Maximum | Operating Temperature: | ||
DOOR MOUNTED
TEMPERATURE GAUGE
The door mounted temperature gauge displays the cabinet internal temperature.
Tall Bottle Retainer (left) and Bin Snugger (right)
WiNE RACK
The wine rack stores bottles of wine, or single