Kenmore 795.751964 Unpacking Your Refrigerator, Installation, Next, When Moving Your Refrigerator

Page 7

Excessive Weight Hazard

Use two or more people to move and install refrigerator.

Failure to do so can result in back or other injury.

UNPACKING YOUR REFRIGERATOR

Remove tape and any temporary labels from your refrigerator before using. Do not remove any warning- type labels, the model and serial number label, or the TechSheet that is attached to back wall of the refrigerator.

To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be easily removed by rubbing a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.

Do not use sharp instruments, rubbing alcohol, flammable fluids or abrasive cleaners to remove tape or glue. These products can damage the surface of your refrigerator. For more information, see the Important Safety Instructions section.

Refrigerator shelves are installed in the shipping position.

Please reinstall shelves according to your individual storage needs.

When Moving Your Refrigerator:

Your refrigerator is heavy. When moving the refrigerator for cleaning or service, be sure to protect the floor. Always pull the refrigerator straight out when moving it. Do not wiggle or walk the refrigerator when trying to move it, as floor damage could occur.

Explosion Hazard

Keep flammable materials and vapors, such as gasoline, away from refrigerator.

Failure to do so can result in death, explosion or fire.

INSTALLATION

1.To avoid vibration, the unit must be level. If required, adjust the leveling screws to compensate for unevenness of the floor. The front should be slightly higher than the rear to aid in door closing. Leveling screws can be turned easily by tipping the cabinet slightly. Turn the leveling screws clockwise ("L_) to raise the unit, counterclockwise (_..L) to lower it.

2.Install this appliance in an area where the temperature is between 55°F (13°C) and 110°F (43°C.) If the temperature around the appliance is too low or high, cooling ability may be adversely affected.

3.Allow the clearance of at least 2 inch from the ceiling and

1 inch from the side walls for better cooling efficiency, ease

of installation, proper air circulation and electrical connections.

&CAUTION: Avoid placing the unit near heat sources, direct sunlight or moisture.

NEXT

1.Clean your refrigerator thoroughly and wipe off all dust accumulated during shipping.

2.Install accessories such as ice cube bin, drawers, shelves, etc., in their proper places. They are packed together to prevent possible damage during shipment.

3.Let your refrigerator run for at least 2 or 3 hours before putting food in it. Check the flow of cold air in the freezer compartment to ensure proper cooling. Your refrigerator is now ready for use.

WARNING

•Be careful when you work with hinge, base cover, stopper etc. You may be injured.

•Do not put hands or foot or metal sticks into air vents, base cover or bottom of refrigerator. You may be injured or receive an electrical shock.

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Kenmore Bottom Mount Refrigerator Freezer Features Refrigerator FeaturesFor prices and additional information call U.S.A Master Protection AgreementsPage USE of Extension Cords To Connect ElectricityRecommended Grounding Method Before YOU Throw Away Your OLD Refrigerator Or FreezerLight p.24 OPull Next InstallationWhen Moving Your Refrigerator Unpacking Your RefrigeratorRemoving Freezer Drawer Handle HOW to Remove DOOR/DRAWER HandlesRemoving Refrigerator Handle Mounted on door Keyhole slots on back of handleScrews mounted on door On back of handle HOW to Replace DOOR/DRAWER HandlesReplacing Refrigerator Door Handle Screws mounted on door Replacing Freezer Drawer HandleRemoving Refrigerator Door Removing and Replacing Refrigerator DoorsCorrectIncorrect Replacing Refrigerator Door Right DoorRemoving Pullout Drawer HOW to Remove and Install the Pullout DrawerDoor Alignment Leveling and Door AlignmentLeveling To remove the base coverEnsuring Proper AIR Circulation Setting the ControlsFood Storage Guide Adjusting Control SettingsWater Dispenser Storing Frozen FoodPackaging recommendations Wine Holder 795.7555* Model Only Refrigerator ShelvesCrisper Suprafresh Crispers with TILT-OUT CompartmentControl To remove lattice Crisper Cover with Lattice on Inner SurfaceCrispers with rails To remove crisper To replace crisperTo replace Glide N Serve Glide N ServeModular Door BIN ControlsICE BIN Dairy BINEGG BOX Tilting DoorPull OUT Drawer TILT-OUT Door BasketDurabase Divider DurabaseReplace with a new cartridge Water FilterDoor Liners and Gaskets General Cleaning TipsLight Bulb Replacement OutsideWhen YOU GO on Vacation Power InterruptionsPreparing for Vacation When YOU should SET the Icemaker Power Switch to O OFFOperation Instructions Normal Soundsyou MAY HearBefore YOU Begin Power drillChoosethe Valvelocation Flush OUT the Tubing Fasten the Shutoff ValveTighten the Pipe Clamp Connect the Tubing to the ValveRefrigerator Connect the Tubing toStart the Icemaker Plug in the RefrigeratorLights do not Work Understanding Sounds YOU MAY HearRefrigerator does not Operate Vibration or Rattling NoiseCheck Then Compressor Motor Seems to RUN TOO MuchDoors will not Close Completely Frost or ICE Crystals on Frozen FoodCubes Produced by Icemaker are TOO Small ICE has OFF-TASTE or OdorThere is Water in the Defrost Drain PAN Refrigerator Seems to Make TOO Much NoiseCheck if Then

795.751994, 795.755434, 795.751964, 795.755464, 795.751934 specifications

The Kenmore 795 series refrigerators, including models 795.755424, 795.755494, 795.751944, 795.755444, and 795.751924, represent a modern approach to kitchen appliance design, emphasizing efficiency, practicality, and advanced technology. These refrigerators are ideal for families and individuals looking for reliability and storage space.

One of the defining features of these Kenmore refrigerators is their spacious capacity. With adjustable shelving and door bins, users can maximize storage for food and beverages. The adjustable shelves are perfect for accommodating larger items, while the door bins provide easy access to condiments and smaller goods. The flexible layout caters to diverse storage needs, enhancing organizational efficiency in the kitchen.

In terms of cooling technology, the 795 series incorporates a sophisticated Multi-Air Flow system that ensures consistent cooling throughout the refrigerator and freezer compartments. This system helps maintain optimal temperatures, reducing the risk of food spoilage and extending the freshness of perishable items. The presence of humidity-controlled crispers is another highlight, ensuring fruits and vegetables retain their texture and nutrients.

Energy efficiency is a significant consideration in today's appliance market. The Kenmore 795 models are designed with energy-efficient technology, helping users save on utility bills while minimizing their environmental impact. With ENERGY STAR certification, these refrigerators meet stringent guidelines for energy consumption, providing peace of mind for eco-conscious consumers.

The Kenmore 795 series also features advanced ice and water dispensers. These dispensers deliver fresh, filtered water and ice on demand, adding convenience for families. Users can easily fill bottles and pitchers without opening the refrigerator door, further enhancing energy efficiency.

In addition to practical features, these refrigerators are designed with a sleek and modern aesthetic. Available in various finishes, including stainless steel, they can seamlessly integrate into any kitchen decor. The user-friendly digital controls and LED lighting add to the appliance's appeal, ensuring a contemporary experience.

Overall, the Kenmore 795.755424, 795.755494, 795.751944, 795.755444, and 795.751924 models provide a blend of practicality, efficiency, and modern design. These refrigerators are an excellent choice for those seeking reliable appliances that cater to the demands of everyday life while enhancing the functionality of their kitchen.
Top Page Image Contents