Typical Installations
A. INSTALLATION ON COPPER PLUMBING USING COMPRESSION FITTINGS
MATERIALS & TOOLS NEEDED
2 compression adaptors, 3/4” NPT x com- pression end to fit existing copper pipe
Teflon tape
Tubing cutter
Sandpaper or emery cloth
2 wrenches, either open end or adjustable jaw, sized to fit compression adaptors
WATER
IN
Apply 4 wraps of
Teflon Tape
Optional
Shutoff
Valve
INLET
3/4” NPT
Optional | WATER |
Shutoff Valve | OUT |
| |
Nut |
|
Brass |
|
Ferrule |
|
Compression |
|
Adaptor |
|
NOTE: Be sure to allow a minimum space of 2” under the filter for removing the sump (to change the cartridge).
Figure 3
B. SOLDERED COPPER INSTALLATION
WATER | IN | OUT | WATER |
IN |
|
| OUT |
Optional | 3/4” Copper |
| Adaptor, 3/4” NPT |
Shutoff |
| x Sweat (Apply | |
Valve (2) | Pipe, as |
| 4 wraps of |
| required |
| Teflon Tape) |
See Note in Figure 3 |
| Figure 4 | |
| C. THREADED INSTALLATION | ||
D. UNDERSINK INSTALLATION
(Filtering Water to One Faucet)
SINK
IN OUT
COLD
Shutoff Valve
WATER | IN | OUT | WATER | |
IN |
|
| OUT | |
Optional | 3/4” | 3/4” Hex | Union | |
Shutoff | Nipple | Fitting | ||
Nipple | ||||
Valve (2) | (2) | (2) | ||
(2) | ||||
|
|
|
NOTE: To change the filter cartridge, refer to the instructions on Pages 11 & 12 in this manual.
NOTE: Be sure to allow
aminimum space of 2” under the filter for removing the sump (to change the cartridge).
See Note in Figure 3 | Figure 5 |
Figure 6
Questions? Call The Kenmore Water Line
6