Heavy Duty Water Filter Model HD-950

Heavy Duty Water Filter Model HD-950

Installation and Operating Instructions

NOTE: This filter housing does not include a filter cartridge.

Choose the appropriate filter cartridge for your needs and install in housing according to the Cartridge Replacement instructions before proceeding with installation. See cartridge selection chart.

Operating Specifications

Pressure Range:	30–100 psi (2.1–6.9 bar)
Temperature Range:	40–100°F (4.4–37.7°C)

Parts Included

Filter Housing Housing Wrench

Tools Required

• 2 adjustable wrenches	• File
• 2 Pipe Wrenches	• Pencil
• Pipe threader	• Pipe Cutter or Hacksaw

Materials Required (not included)

Depends on type, size, and location of pipe on which filter will be installed. Measure the pipe to determine what size nipples, union, and valve you will need. If you are not installing on 1-inch pipe, you will also need to purchase the appropriate size bushings. Consult your local hardware store to learn more about your particular installation needs.

NOTE: Galvanized fittings must be used with galvanized pipe.

Optional Materials

•150456 WBA Mounting Bracket

•Jumper Wire (See your Local Dealer)

NOTE:

•For cold water use only.

•Make certain that installation complies with all state and local laws and regulations.

•The contaminants or other substances removed or reduced by the selected cartridge are not necessarily in your water. Ask your local water municipality for a copy of their water analysis, or have your water tested by a reputable water testing lab.

•After prolonged periods of non-use (such as during a vacation) it is recommended that the system be flushed thoroughly. Let water run for 5–6 minutes before using.

•The filter cartridge used with this system has a limited service life. Changes in taste, odor, color, and/or flow of the water being filtered indicate that the cartridge should be replaced.

•Some harmless bacteria may attack cellulose media cartridges. The CP5-BBS is not recommended on non-chlorinated water. If your cartridge seems to disintegrate or develops a musty or moldy odor, switch to a synthetic media cartridge or consult the manufacturer.

Tested and Certified by NSF International to NSF/ANSI Standard 42 with cartridge RFC-BBS. See Performance Data Sheet in Manual for specific claims.

Precautions

WARNING: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

CAUTION: Filter must be protected against freezing, which can cause cracking of the filter and water leakage.

CAUTION: The rubber O-ring provides the water-tight seal between the cap and the bottom of the housing. It is important that the O-ring be properly seated in the groove above the threads of the housing or a water leak could occur.

CAUTION: Because of the product’s limited service life and to prevent costly repairs or possible water damage, we strongly recommend that the bottom of all plastic housings be replaced every ten years. If the bottom of your housing has been in use for longer than this period, it should be replaced immediately. Date the bottom of any new or replacement housing to indicate the next recommended replacement date.

Technical Support: 1-800-645-5426

(M-F 7:30 am - 5:00 pm CST)

11/03

145054 Rev G