Kenmore HD-950 manual Cartridge Replacement, Troubleshooting, Replacement Parts

Page 3

Cartridge Replacement

A.Turn off water supply to filter. Depress red pressure-relief button on top of filter. Use wrench to unscrew bottom of housing.

NOTE: If turning off water supply to filter will also turn off water supply to the rest of the home, be sure to fill a bucket of water first to allow you to clean housing after it has been removed.

B.Locate and remove large O-ring, wipe clean of lubricant and set aside. Discard used cartridge. Rinse out bottom of housing and fill about 1/3 full with water. Add about 2 tablespoons of bleach and scrub cap and bottom of housing with nonabrasive sponge or cloth. Rinse thoroughly. Lubricate O-ring with clean silicone grease. Insert O-ring back into groove and smooth into place with finger. Insert new cartridge over standpipe in bottom of housing.

C.Screw bottom of housing onto the cap and hand-tighten. DO NOT OVER-TIGHTEN.

Turn on water supply slowly to allow filter to fill with water. Depress red pressure-relief button to release trapped air. Check for leaks before leaving installation.

NOTE: After installation, flush the cartridge for 10 minutes, wait one hour, then flush again for 10 minutes before using the water.

A

B

C

Troubleshooting

Leaks between cap and bottom of housing:

1.Turn off water supply and depress pressure-relief button.

2.Clean and lubricate O-ring with silicone grease. Also, clean the groove where the o-ring seats. Replace o-ring back in groove above threads. Screw bottom of housing back on cap securely by hand. Do not overtighten.

3.Turn on water supply. If leaks persist, or if there are other leaks on the system, turn off water supply. Call Technical Support at 1-800-645-5426.

Leaks on inlet/outlet connections:

1.Turn off water supply. For brass fittings, tighten nut 1/2-turn with wrench.

2.Turn on water supply. If leaks persist, or if there are other leaks on system, turn off water supply. Call Technical Support at 1-800-645-5426.

Replacement Parts

1

151039

Pressure-relief Assembly

 

2

154531

Cap, 1” HFPP Blue

5

3

151122

O ring (OR-100)

 

4

153029

Heavy Duty Blue Housing

 

5

150296

SW-3 Housing Wrench

 

For replacement parts, contact your nearest retailer or call Culligan Consumer Services @ 1-888-777-7962. The HD-950 is covered by a limited five year warranty. See warranty for details.

1

2

3

4

3

Image 3
Contents Heavy Duty Water Filter Model HD-950 Installation Leaks between cap and bottom of housing Cartridge ReplacementTroubleshooting Replacement PartsRFC-BBS MaintenanceCartridge Selection Performance Data HD-950Filtro Para Agua De Gran Capacidad Modelo HD-950 Instalación Siga el diagrama paso a pasoGoteras entre el pocillo y la tapa Instrucciones para Reemplazar el Cartucho FiltranteReparaciones RepuestosRFC-BBSA Diagrama Para Reemplazar El Cartucho FiltranteDatos de Funcionamiento HD-950 Mantenimiento