Precision Power G41810 manual 456

				er
			cisionPow
			Pre	456
				FRX-
	co	L	Inputs
atte-nuation	inpmbined		L
	uts • in
12dB in		R	R
			rear	front

							er
							ssov
						tronicCro einUSA
					/SixWayElec		Mad
					r/Five
					Fou				+
								_
							344	752		arFillLevel
							52
						192	3441	80	7.4K	Re
					344	752		1.77K	Tweeter
					52		80	Range		Rear
				192	3441	80	7.4Kr	Mid
			172	272	80	1.77K	Tweete
			92			MidRange
		70		56	492		t
	16	2536	22	264	MidBass		Fron
	10			Pass
+		7	46	Low
_		+10	SubSonic	oofer
		Gain
er		LowPass		Subw
Pow
					Power
				Precision
Ground	te
RemoPower

Before beginning, disconnect the negative (-) terminal of the battery prior to working on the positive (+) terminal to prevent a short to ground. This is important, unless you want to spend the rest of your life with a nickname like "Sparky," or "Smokey." Reconnect the negative terminal only after all connections have been made.

To prevent damage to the crossover while driving, mount it in a secure place. Choosing the appropriate location will depend upon your vehicle and the complexity of your system design. Typical mounting locations would be in the same location as your amplifiers and or crossovers. Never mount the component in a location that would subject it to immersion or exposure to water.

Once a location has been chosen, securely mount the FRX-456using the four screws supplied. Be Careful! Inspect the area underneath to be sure you are not drilling into wires, brake or fuel lines, etc. that could be damaged by the drill bit or screws.

10 3