HB2302 / HBZ2601
5. For safe operation
1.Operate power equipment only at reasonable
2.To reduce sound levels, limit the number of pieces of equipment used at any one time.
3.Operate power blowers at the lowest possible throttle speed to do the job.
4.Check your equipment before op- eration, especially the muffler, air intakes and air filters.
WORKING PLAN
• When planning your work sched- ule, allow plenty of time to rest. Limit the amount of time over which the product is to be used continuously to somewhere around 30 ~ 40 minutes per ses- sion, and take 10 ~ 20 minutes of rest between work sessions. Also try to keep the total amount of work performed in a single day under 2 hours or less.
FUEL
WARNING
To reduce the risk of fire and burn injury:
a) Handle fuel with care. It is highly flammable.
b)Do not smoke while handing fuel.
c)Do not refuel a hot engine.
d)Do not refuel a running engine.
e)Avoid spilling fuel or oil. Always wipe unit dry before using.
f)Move at least 10 ft. (3 meters) away from the fueling point be- fore starting engine.
g)Always store gasoline in a con- tainer approved for flammable liq- uids.
h)Make sure the unit is properly as- sembled and in good operating condition.
BEFORE STARTING THE
ENGINE
•Each time before starting the en- gine, inspect the entire unit to see if every part is in good order and is securely tightened in place. If
GB-6
any damage is found in the fuel line, the exhaust line, or the igni- tion wiring, do not use the blower until it has been repaired.
IMPORTANT
•Before starting operation, always make sure to check if any ob- stacles are left inside the volute case. The obstacles may cause damage on fan and volute case and serious injury.
WARNING
•Never use the blower without the screen at the air intake of the blower. Before each use, check that, the screw (1) is securely tightened and is free from any damage.
•Never remove debris from the in- take screen while the engine is running. Contact with rotating blower fan may result in a serious personal injury.
(1)Screw
(2)Air intake screen (Air inlet net)
WARNING
•To reduce the risk of injury asso- ciated with contacting rotating parts, stop the engine before in- stalling or removing attachments. Do not operate without net in place. Always disconnect the spark plug before performing maintenance or accessing mov- able parts.
USING THE PRODUCT
1.Check the work area that the blower will be used in and remove or cover all valuables that may be damaged by the air blast or thrown debris.
2.To reduce the risk of injury asso- ciated with thrown objects.
a)Watch out for children, pets, open windows or freshly washed cars, and blow debris safely away.
b)Use the full blower nozzle exten- sion so the air stream can work close to the ground.