Murray 425001x99A manual HOW to Assemble the Gauge Wheels, Maintenance Free Battery

Page 12

ASSEMBLY

HOW TO ASSEMBLE THE GAUGE WHEELS

Use the fasteners shown below to install the gauge wheels. The fasteners are shown at full size.

(A)

(B)

31x11

17x91

 

1.Attach the gauge wheels to the axle bolts with the fasteners.

NOTE: The axle bolt is mounted in the LOW position. To change the position to a higher cutting position, see “How To Adjust The Gauge Wheels” in the Maintenance section.

Axle Bolt

B

A

Gauge Wheel

Figure 3

MAINTENANCE FREE BATTERY

IMPORTANT: Before you attach the battery cables to the battery, check the battery date. The battery date tells if the battery must be charged.

1.Check the top and the side of the battery for the location of the battery date (Figure 4).

2.If the battery is put into service before the battery date, the battery cables can be attached without charging the battery. See “How To Install The Battery Cables”.

3.If the battery is put into service after the battery date, the battery must be charged. See “How To Charge The Maintenance Free Battery”.

HOW TO CHARGE

THE MAINTENANCE FREE BATTERY

WARNING: When you charge the battery, do not smoke. Keep the battery away from any sparks. The fumes from the battery acid can cause an explosion.

1.Remove the battery and battery tray.

2.Remove the protective cap from the battery terminal.

3.Use a 12 volt battery charger to charge the battery. Charge at a rate of 6 amperes for one hour. If you do not have a battery charger, have an authorized service center charge the battery.

4.Install the battery and battery tray. Make sure the positive (+) terminal is on the left side.

HOW TO INSTALL THE BATTERY CABLES

WARNING: To prevent sparks, fasten the red cable to the positive (+) terminal before you connect the black cable.

Use the fasteners shown below to install the battery cables. The fasteners are shown at full size.

(A)

(B)

2x82

14x79

1.Remove the protective cap from the battery terminal.

2.Fasten the red cable to the positive (+) terminal with the fasteners as shown (Figure 4).

3.Fasten the black cable to the negative (-) terminal with the fasteners as shown.

 

Positive

 

B

(+)

Red

Terminal

 

Cable

 

 

A

 

 

Battery

Black Cable

 

 

A

Battery Tray

Figure 4

 

F-050722L

12

Image 12
Contents Model Table of Contents OWNER’S Information Environmental AwarenessII. Slope operation Safe Mowing Guide Safe Mowing Guide Safe Mowing Guide Steps to Follow Before MowingSafety Warning Pictorials International PictorialsInternational Pictorials Control And Operating PictorialsAssembly AssemblyHOW to Install the Seat HOW to Assemble the Steering WheelHOW to Assemble the Gauge Wheels Maintenance Free BatteryHOW to Charge Maintenance Free Battery HOW to Install the Battery CablesHOW to Prepare the Engine Check the Level of the Mower HousingIMPORTANT! Before YOU Start Mowing Check the TiresOperation Location of ControlsLift Lever Electrical Safety System HOW to Operate the Ignition KEY SwitchHOW to USE the Throttle Control AttachmentsHOW to USE Blade Rotation Control HOW to USE the Shift LeverSee the Instruction Book for the Attachment HOW to SET the Parking Brake HOW to Change the Cutting HeightHOW to Stop the Unit HOW to Transport the UnitHOW to Operate with the Mower Housing HOW to Operate the Unit on HillsHOW to Start the Engine Before Starting the EngineCarburetor Operating Tips Mowing and Bagging TipsMaintenance Frequency Maintenance Required CommentsHOW to Check the Muffler General RecommendationsHOW to Remove and Install the Blade HOW to Sharpen the BladeInspect Blade HOW to Adjust the Blade Rotation Control HOW to Check and Adjust the Clutch HOW to Check and Adjust the Drive BrakeHOW to Adjust the Shift Lever Disconnect the adjuster nut from the shifter bracket FigureWhere to Lubricate HOW to Check the Fuel FilterHOW to Remove the Mower Housing HOW to Install the Mower HousingHOW to Adjust the Gauge Wheels HOW to Level the Mower Housing HOW to Replace Motion Drive Belt RemovalInstallation HOW to Replace the Mower Drive Belt HOW to Install the Wheels Front WheelHOW to Replace the Fuse HOW to Replace the Light BulbHOW to Clean the Mower Housing BatteryTrouble Shooting Chart 050722L USA050722L Repair Parts Chassis & HoodKey Description Motion Drive Motion Drive Steering Steering Repair Parts Mower Housing Suspension Mower Housing Suspension Mower Housing Repair Parts Repair Parts Engine Mount Engine Mount Wiring Harness for Electrical System 050722L 050722L 050722L Index Model No Model No Bushel Capacity