HOW to Remove the Mower Housing

1.Move the blade rotation control to the DISENGAGE position.

2.Move the lift lever to the level adjustment position (Figure 21).

HOW TO INSTALL THE MOWER HOUSING

1.	Push the mower housing under the right side of the unit.
2.	Put the mower drive belt around the stack pulley. Make sure

WARNING: The lift lever is spring loaded. Make sure the lift lever is locked in the LEVEL ADJUST- MENT position.

3.Remove the hair pins and the washers from the adjuster arms (Figure 22). See illustra- tions “C” and “D”.

4.Remove the hair pins and wash- ers from the suspension links. See illustrations “A” and “B”.

Level Adjustment
Position	Figure 21

	the “V” side of the mower drive belt is against the stack pulley.
	Also, make sure the mower drive belt is not twisted.
3.	Attach the front hanger to the axle support with the hanger
	rod. Fasten with the fasteners as shown. See illustration “F”.
4.	Make sure the mower drive belt is between the stack pulley
	and the two belt guides. See illustration “G”.
5.	Attach the suspension links to the lifter assembly. Fasten
	with the washers and hair pins. See illustrations “A” and “B”.
6.	Attach the right and the left adjuster arms to the suspension
	brackets. Fasten with the washers and hair pins. See illustra-
	tions “C” and “D”.

5.Disconnect the extension spring from the blade control rod. See illustration “E”.

6.Disconnect the front hanger from the axle support. See illustration “F”.

8.Pull the mower housing away from the right side of the unit.

9.To operate without the mower housing, move the lift lever to the TOP position.

7.	Attach the extension spring to the blade control rod. See
	illustration “E”.
8.	Move the blade rotation control to the ENGAGE position.
	Make sure the mower drive belt is inside all the belt guides.
9.	Make sure the mower housing is level. See the instructions on
	“How To Level The Mower Housing”.
10.	Check the operation of the blade rotation control. See the in-
	structions on “How To Adjust The Blade Rotation Control”.