Weed Eater 530086743, RTE113 User Replaceable Service Parts, Troubleshooting Table Cause Remedy

Page 8

USER REPLACEABLE SERVICE PARTS

REPLACEMENT PART

PART NUMBER

Spool with 0.065! Trimmer Line

952701663

Assist Handle

530403805

Bolt Carriage, 1/4-20

530403886

Wing Nut

530016152

Shield Assembly (RTE113)

530403915

Shield Assembly (RTE114)

530403914

Edge Guide (RTE113)

530403845

Edge Guide (RTE114)

530403824

 

 

 

 

WARNING: Perform the following steps after each use.

S Stop the unit and disconnect the power source when not in use.

SCarry the unit with motor stopped.

SStore the unit so the line limiter blade can- not cause injury.

S Store unit and extension cord indoors in a high, dry place out of the reach of children. Store unit unplugged.

SStore unit with all guards in place. Position unit so that any sharp object cannot acci- dentally cause injury.

TROUBLESHOOTING TABLE

WARNING: Always stop unit and disconnect from the power source before per- forming all of the recommended remedies below except remedies that require unit to be operating.

TROUBLE

CAUSE

REMEDY

Trimmer head

1.

Crowding trimmer line

1.

Allow tip of line to do the cutting.

stops under a

 

against material being

 

 

load or does not

 

cut.

2.

Contact your authorized service dealer.

turn when switch

2.

Electrical failure.

is pressed.

3.

Thrown circuit breaker.

3.

Check breaker box.

 

4.

Debris stopping head.

4.

Remove debris.

 

 

 

 

 

Line does not

1.

Line improperly routed

1.

Check line routing.

advance or

 

in head.

 

 

breaks while

2.

Line improperly

2.

Rewind line tightly and evenly.

cutting.

 

wound into spool.

3.

Use only 0.065 in. (1.65 mm) dia. line.

 

3.

Incorrect line size

 

4.

Not enough line

4.

Remove cover and pull 4 in.

 

 

outside of head.

 

(10 cm) of line out of head.

 

5.

Dirt buildup on unit.

5.

Clean unit.

Line welds onto

1.

Line size is incorrect.

1. Use only 0.065 in. (1.65 mm) dia. line.

spool.

2.

Incorrect spool.

2. Replace with correct spool.

 

3.

Line is being crowded

3. Cut with tip of line fully extended.

 

 

against material being

 

 

 

 

cut.

 

 

Line releases

1.

Line improperly

1. Check line routing.

continuously.

 

routed in head.

 

 

 

2.

Spool damaged.

2. Replace spool.

 

 

 

 

Line usage is

1.

Line improperly routed

1. Check line routing.

excessive.

 

in head.

 

 

 

2.

Line size is incorrect.

2. Replace spool.

 

3.

Crowding line against

3. Cut with tip of line fully extended.

 

 

material being cut.

4. Replace spool.

 

4.

Spool worn or damaged.

 

 

 

Line pulls back

1. Too little line outside

1. Remove cover and pull 4 inches

into head.

 

of head.

 

(10 cm) of line outside of head.

 

2. Line size incorrect.

2. Use only 0.065 in. (1.65 mm) dia. line.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Advertencia AvertissementOperator Safety Electrical SafetyUnit Safety Cutting SafetyMaintenance Safety Transporting and StorageAdjusting Assist Handle Attaching the ShieldOperating Instructions Correct Operating Position Advancing the Cutting LineBefore Each USE After Each USEUser Replaceable Service Parts Troubleshooting Table Cause RemedyINC Policy of Electrolux Home Prod

530086743, RTE114, RTE113 specifications

The Weed Eater RTE113 and RTE114, along with the part number 530086743, are powerful and reliable electric string trimmers designed for homeowners seeking an efficient solution for lawn maintenance. Both models stand out due to their user-friendly features, cutting-edge technologies, and robust design, making yard care tasks easier and more enjoyable.

The RTE113 and RTE114 trimmers are equipped with electric motors that provide consistent performance without the noise and emissions associated with gas-powered models. This makes them an eco-friendly choice for those looking to maintain their gardens while minimizing their environmental impact. The lightweight design of these trimmers ensures easy maneuverability, allowing users to navigate their yards with ease. Weighing in at just a few pounds, both models reduce user fatigue during prolonged use.

One of the standout features of the RTE113 and RTE114 is the automatic line feed system, which eliminates the need for manual line adjustments. This ensures that the cutting line advances effortlessly as needed, helping users maintain an uninterrupted work rhythm. The trimmers are equipped with a dual line system that allows for a wider cutting width, enabling faster trimming and reducing the overall time spent on yard work.

In terms of functionality, the trimmers feature an adjustable telescoping shaft that can accommodate different user heights, enhancing comfort during operation. Additionally, the ergonomic handle design provides a secure grip, making it easier to navigate around flower beds, fences, and other obstacles.

The RTE113 and RTE114 models also incorporate advanced technologies, such as a powerful 13-amp motor, which delivers ample cutting power for tackling tough weeds and grass. The 530086743 part number is crucial for users looking for replacement parts, ensuring that the trimmers can stay in top condition for years to come.

Overall, the Weed Eater RTE113 and RTE114, along with the 530086743 components, are outstanding choices for homeowners seeking effective and environmentally friendly lawn care solutions. Their combination of user-friendly features, powerful motors, and thoughtful design make them excellent tools for keeping your garden tidy and well-maintained.
Top Page Image Contents