Weed Eater A Comprehensive Guide to the Choke Symbol for Trimmer Operation
Page 7

cause high moisture absorption into the fuel/ oil mixture leading to oil and fuel separation.

HELPFUL TIP

If your engine switch reads “push to stop”, it is always in the ON position.

HOW TO STOP YOUR UNIT

STo stop the engine, push and hold the STOP switch in the STOP position until the engine stops.

SIf engine does not stop, move choke to the FULL CHOKE position.

HOW TO START YOUR UNIT

WARNING: The trimmer head will turn while starting the engine. Avoid any con- tact with the muffler. A hot muffler can cause serious burns.

HELPFUL TIP

If your engine still does not start after following these instructions, please call 1-800-554-6723.

STARTING A COLD ENGINE (or a warm engine after running out of fuel)

Starting Position

1.Set unit on a flat surface.

2.Slowly press the primer bulb 6 times.

3.Move choke lever to the FULL CHOKE position.

4.Squeeze the throttle trigger fully and hold through all remaining steps.

Primer Bulb

Choke

Lever

Starter Handle

5.Pull starter rope handle sharply until engine sounds as if it is trying to start, but do not pull rope more than 6 times.

6.As soon as engine sounds as if it is trying to start, move choke lever to HALF CHOKE position.

7.Pull starter rope sharply until engine runs, but no more than 6 pulls.

NOTE: If the engine doesn’t start after 6 pulls (at the HALF CHOKE position), move the choke lever to the FULL CHOKE position and press the primer bulb 6 times. Squeeze and hold the throttle trigger and pull the starter rope 2 more times. Move the choke lever to the HALF CHOKE position and pull the start- er rope until the engine runs, but no more than 6 pulls. If the engine still doesn’t start, it is probably flooded. Proceed to

STARTING A FLOODED ENGINE.

8.Once the engine starts, allow it to run 10 se- conds, then move the choke lever to the RUN position. Allow the unit to run for 30 more seconds at RUN before releasing the throttle trigger.

NOTE: If engine dies with the choke le- ver in the RUN position, move the choke lever to the HALF CHOKE position and pull the rope until engine runs, but no more than 6 pulls.

STARTING A WARM ENGINE

1.Move the choke lever to the HALF CHOKE position.

2.Squeeze and hold the throttle trigger. Keep throttle trigger fully squeezed until the en- gine runs smoothly.

3.Pull starter rope sharply until engine runs, but no more than 6 pulls.

4.Allow engine to run 15 seconds, then move the choke lever to RUN.

NOTE: If engine has not started, pull starter rope 5 more pulls. If engine still does not run, it is probably flooded.

STARTING A FLOODED ENGINE

Flooded engines can be started by placing the choke lever in the RUN position; then, pull the rope to clear the engine of excess fuel. This could require pulling the starter handle many times depending on how badly the unit is flooded. If the unit still doesn’t start, refer to TROUBLESHOOTING TABLE or call 1-800-554-6723.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Manual de Instrucciones Manuel d’Instructions Identification of Safety Symbols Operator Safety Safety RulesTransporting and Storage Unit / Maintenance SafetyFuel Safety Cutting SafetyNut AssemblyAdjusting the Handle Attaching ShieldOperation Starting a Flooded Engine HOW to Stop Your UnitHOW to Start Your Unit Starting a Warm EngineAlways Wear Operating PositionTrimmer Line Advance Cutting MethodsMaintenance Replace Spark Plug Service and AdjustmentsLine Replacement Carburetor Idle Speed AdjustmentOther Seasonal StorageFuel System EngineTroubleshooting Table Cause Remedy Limited WarrantyWeed Eater Canada, contactIntermediate 125 hours Extended 300 hours

545186837, FL23 specifications

The Weed Eater FL23 is a standout model in the world of string trimmers, designed to make yard maintenance a breeze. With its powerful 23cc 2-cycle engine, it packs enough punch to tackle tough weeds and overgrown vegetation with ease. Weighing only around 10 pounds, this lightweight trimmer provides easy maneuverability, allowing users to navigate tight spaces and difficult angles without straining their arms or back.

One of the main features of the FL23 is its innovative 18-inch cutting swath, which ensures a wide area is covered in a shorter amount of time. This efficiency makes it an ideal choice for homeowners looking to maintain their lawns without spending all weekend on yard work. The trimmer also boasts a bump head line advancement system, which allows users to quickly and easily feed more line simply by tapping the trimmer's head against the ground. This feature saves time and effort, eliminating the need to pause and manually adjust the line.

In terms of technology, the Weed Eater FL23 incorporates anti-vibration technology, which significantly reduces the amount of vibration felt by the user during operation. This ensures a more comfortable experience, especially during extended use. Additionally, the trimmer's ergonomic design, featuring a straight shaft, provides optimal balance and control, making it easier to maneuver and maintain precision while trimming.

Fuel efficiency is another key characteristic of the FL23. With its 2-cycle engine, it delivers a reliable performance while using a gas and oil mix that minimizes emissions. This makes it an environmentally friendly option for those who want to maintain their gardens without contributing excessively to pollution.

The Weed Eater FL23 is built for durability, featuring high-quality materials that can withstand the rigors of regular use. The robust construction ensures that users can rely on this trimmer season after season. Whether you are cutting through grass, edging flowerbeds, or clearing out tough weeds, the FL23 is designed to deliver consistent, effective results every time.

In conclusion, the Weed Eater FL23 is a versatile and reliable tool for any homeowner looking to maintain their yard. With its blend of power, technology, and user-friendly features, it stands as a top choice in the market of string trimmers.
Top Page Image Contents