Weed Eater 545186762 User Replaceable Service Parts, Unit will not function properly Hub, Small

Page 8

8. Insert the line into the exit hole in the hub	Line in Notch
as shown in the illustration.

9. Align the notch with the line exit hole.

10.Push the spool into the hub until it snaps into place.

11.Pull on the line extending outside the hub to release it from the notch; otherwise, the

unit will not function properly.

	Hub	Line exit hole
	Small	Line exit hole
	Small
	Hole
	Spool
	Tap
	Button

USER REPLACEABLE SERVICE PARTS

REPLACEMENT PART	PART NUMBER
Spool with 0.065″ Trimmer Line	952701663
Assist Handle	530403805
Bolt Carriage, 1/4-20	530403886
Wing Nut	530016152
Shield Assembly	530404076
Edge Guide	530403845

STORAGE

WARNING: Perform the following steps after each use.

S Stop the unit and disconnect the power source when not in use.

SCarry the unit with motor stopped.

SStore the unit so the line limiter blade can- not cause injury.

SStore unit and extension cord indoors in a high, dry place out of the reach of children.

Store unit unplugged.

SStore unit with all guards in place. Position unit so that any sharp object cannot acci- dentally cause injury.

8

Image 8

Contents Advertencia AvertissementElectrical Safety Safety RulesOperator Safety Unit Safety Cutting SafetyMaintenance Safety Transporting and StorageAssembly Tube AssemblyInstallation of Assist Handle Attaching Edge Guide and ShieldOperation Operating Instructions Attach the Extension Cord to Your TrimmerCorrect Operating Position Advancing the Cutting LineMaintenance Service and AdjustmentsBefore Each USE After Each USEUser Replaceable Service Parts Insert the line into the exit hole in the hubUnit will not function properly Hub SmallIncorrect line size Troubleshooting Table Cause RemedyElectrical failure Weed Eater Husqvarna Outdoor Products IncCanada, contact