NOTE: If shield is not properly installed, dam- age to unit (including motor failure) will result.
1.Place the shield onto the motor housing. Ensure the cutting head remains free to rotate and the line is not caught between the shield and the motor housing (see fol- lowing illustration).
Motor Housing
Line Limiter
Pin
Cutting Head
Shield
2.Align the installation arrow on the shield with the installation arrow on the motor housing as shown.
Installation arrows
3.Twist the shield as illustrated until it snaps securely into place. Make sure the shield is assembled to the unit as shown in the illustration below and in the KNOW YOUR TRIMMER section of this manual.
WHEEL ASSEMBLY
1.Fit the two halves of the wheel together (see illustration).
Wheel
2.Attach the wheel to the trimmer. Make sure the wheel is fitted into the groove on the motor housing.
Motor | Groove | |
Housing | ||
|
3.Clip the wheel together securely on the other side. The wheel should turn freely.
INSTALLATION OF ASSIST HANDLE
1.Press the two buttons on the sides of the switch handle.
Button
Button
Assist Handle
2.Push the assist handle over the buttons and release the buttons.
3.Adjust the handle to the most comfortable operating position by pressing the buttons and moving the handle.
6