Weed Eater 952711895 instruction manual Operating Instructions

Page 8

POWER CORD

The POWER CORD is where you attach your extension cord to the unit.

TRIGGER SWITCH

The TRIGGER SWITCH is used to turn on the unit. Squeeze the trigger switch to operate the unit. Release to stop.

LINE LIMITER PIN

The LINE LIMITER PIN cuts the cutting line to the proper cutting length.

TRIMMER HEAD

The TRIMMER HEAD holds cutting line and rotates during operation.

OPERATING INSTRUCTIONS

Use only a voltage supply as specified on your unit.

SELECT AN EXTENSION CORD

Extension Cord Gauge Chart

Length of Cord

Gauge

25

Ft. (7.5 m)

18 Gauge

50

Ft. (15 m)

16 Gauge

100 Ft. (30 m)

16 Gauge

 

 

 

Extension cords are available for this unit.

ATTACH THE EXTENSION

CORD TO YOUR TRIMMER

1.Form a loop in your extension cord.

2.Push the loop through the slot in the han- dle (see illustration).

3.Position the loop over the cord retainer and pull back to secure.

4.Connect power cord of unit to extension cord.

CORRECT OPERATING POSITION

TrimmingEdging

WARNING: Always wear eye protec- tion. Never lean over the trimmer head. Rocks or debris can ricochet or be thrown into eyes and face and cause blindness or other serious injury.

When operating unit, stand as shown and check for the following:

SWear eye protection and heavy clothing. S Hold trigger handle with right hand and as-

sist handle with left hand.

S Keep unit below waist level.

S Cut only from your right to your left to en- sure debris is thrown away from you. With- out bending over, keep line near and paral- lel to the ground and not crowded into material being cut.

AUTOMATIC LINE FEED SYSTEM

When the trimmer is initially started, a small length of cutting line is fed out.

Line Limiter Pin

After approximately 5 seconds, the line will be cut to the correct length by the line limiter pin as the motor reaches full speed. Make sure the motor is up to full speed before trim- ming. If the noise of the cutting line being cut cannot be heard, more line will need to be fed out.

To feed more line:

SAllow the motor to stop completely; then, re- start the motor and allow it to reach full speed.

8

Image 8
Contents Advertencia AvertissementIdentification of Safety Symbols Safety Rules Safety Information On the UnitOperator Safety Electrical SafetyUnit Safety Cutting SafetyAssembly Housing Wheel AssemblyInstallation of Assist Handle Height Adjustment OperationKnow Your Trimmer Head Wheel Line Limiter PinOperating Instructions Trimming EdgingAfter Each USE MaintenanceBefore Each USE Air Vents Groove Service and AdjustmentsReplacing the Line Cut out Area of spool Eyelet User Replaceable Service PartsReinstall the spool cap Troubleshooting Table Cause Remedy Weed Eater Statesville RoadCanada, contact