STANDARDS: This edger attachment is Listed by Underwriter's Laboratories, Inc., in accordance with U L Standard 1602, "Gasoline- Engine- Powered, Rigid-
25cc Powerhead (with trimmer attachment)
CARTON CONTENTS
Check carton contents against the fol-
lowing list.
Model C944.511573
•Edger attachment
•Handlebar
•Handlebar mounting bracket for 1" (2.5 cm) shaft
•Handlebar mounting bracket for 7/8" (2.2 cm) shaft
•Bracket cover (2)
•Handlebar bracket screws (4)
•Attachment Hanger
•Hex Wrench
Examine parts for damage. Do not use damaged parts.
NOTE: If you need assistance or find parts missing or damaged, contact your Sears Service Centre.
ASSEMBLY
_,WARNING: | If received as- |
sembled, repeat all steps to ensure
your unit is properly assembled and all fasteners are secure.
• A hex wrench (provided) is required
for assembly.
HANDLEBAR ASSEMBLY
_DANGER: RISKOFCUT. To
avoid serious injury, the barrier portion of the handlebar must be installed as
shown on the upper shaft of the pow- erhead to provide a barrier between operator and the spinning blade. At- tach handlebar mounting bracket above arrow on safety warning decal on the upper shaft (powerhead end of unit). Ensure handlebar is positioned
on mounting bracket at the end of the arrow on the handlebar decal.
NOTE: Two mounting brackets are in- cluded with this attachment. Both brack-
ets are provided to adapt this attach- ment for use with powerheads that have either a 1" (2.5 cm) diameter or a 7/8"
(2.2 cm) diameter upper shaft. The cor- rect bracket must be used to ensure
that the handlebar is mounted securely to the upper shaft before use.
.....................944.51556
Bracket Cover
Mountinc
Bracket /
i
1.Place the mounting bracket over the upper shaft above the arrow on the safety label. Be sure to use the correct mounting bracket for either the 1" (2.5 cm) or 7/8" (2.2 cm) di- ameter upper shaft.
2.Position one of the bracket covers
under the upper shaft and align the
mounting bracket and the bracket cover screw holes. Insert two
screws into the screw holes.
3.Secure the mounting bracket by
tightening the screws with the hex wrench.
4.Locate the decal on the handlebar. This decal includes an arrow. Posi- tion the handlebar with the mount- ing bracket at the end of the arrow.
5.Position the second bracket cover
over the handlebar. Align the mounting bracket and the bracket
cover screw holes. Again make sure the handlebar is at the end of the arrow.
6.Insert two screws and hand tighten only. Be sure the handlebar is installed correctly; then, tighten
each screw securely with the hex wrench.
NOTE: Adjustments can be made by loosening the bracket cover screws and moving the mounting bracket or
handlebar up or down the shaft. Be sure the handlebar is installed correct-
ly; then, retighten each screw securely with the hex wrench.